The four most common omissions in decoration must be reworked!

If the foundation is not laid well, it is easy to have various problems in the later stage, such as water leakage and wall cracking. The following are the four most common decoration omissions in decoration.

Omission 1: the construction quality is poor if it is not in accordance with the specifications.

There are many places that do not conform to the specifications. It is common that the gap between lintel and door frame exceeds the specifications. There is no jointing or even staggered joints between the wall tiles, the gap of the ceiling inspection opening is too large, the edge sealing is not straight, the gap between the floor tile and the sliding door frame is too large, and the angle of yin and yang is not vertical.

Experts reminded that the construction should be carried out in strict accordance with industry norms. The owner shall invite professionals to assist in the acceptance. Thereby avoiding potential safety hazards.

Omission 2: the floor tiles are not flat-fell, and the heating nozzles are not protected.

Due to the mismatch between the wall tiles and the corner, the gap between the floor tiles and the corner is too large. Another situation is that the wall brick can't hold down the floor tile, resulting in a gap at the junction of the wall brick and the floor tile. These conditions are all caused by the low construction quality in the construction process.

Experts remind: the seamless wall and floor tiles lead to the gap between the floor tiles and the corner is too large, which is a common problem in room decoration. Although this situation can be repaired later, it will cause unsightly joints between walls and tiles. Before the heating installation, the nozzle of the heating pipe was completely exposed and there was no corresponding protection. There are many materials in the construction site, and the nozzle of the heating pipe is not protected. Once a heavy object hits the nozzle of the heating pipe, it is likely to cause the nozzle deformation, and the heating will leak and damage the floor after installation.

Omission 3: the wall brick is damaged and not replaced.

Small holes and damage can be clearly seen on some wall bricks, but the construction team was too troublesome to put on new bricks in time. Experts remind: the acceptance of wall tiles should be cautious, and the damaged wall tiles should be replaced in time, so as not to affect the overall beauty of the wall.

Omission 4: The wire connection is confused.

When wiring the house, connect the wires randomly. Experts remind: to avoid these situations, the first thing is to invite experienced electricians. Secondly, when wiring, the plastic sheath line or other insulated wires used should be protected through pipes and cannot be directly buried in cement or lime paint. Because the wire directly buried in the wall has been "dead" in the wall, and it can't be pulled out. Once a certain section of the line is damaged and needs to be replaced, it can only be re-wired. When changing wires, there can be no connectors in the middle. If the joint is directly buried in the wall, with the passage of time, the insulating tape at the joint will age, and long-term burial in the wall will cause leakage. Therefore, we must not violate the norms and connect wires indiscriminately to avoid potential accidents such as leakage.