How to install anti-mosquito screens and how to clean them

Hot and humid environments can easily breed mosquitoes, so it is necessary to install an access screen at home. Next, the editor will tell you how to install mosquito screens and how to clean mosquito screens.

1. How to install anti-mosquito screens

1. First assemble the frame of the screen window

Take out two PVC pieces according to the size to make the screen window. Use two wide ones to make the screen window. According to the measured size, the high PVC should be more than 3-4 cm larger than the inner frame of the window. The wide PVC should be more than 1 cm larger than the inner frame of the window. When making the high screen window, When the PVC is inserted into the corner, push it to the bottom. Install the taller PVC first, and then insert the wider PVC in order, so that the window frame is assembled.

2. Press the prepared gauze into the PVC

Take out the gauze and lay it on the completed frame, take a good angle, and press the gauze with a gauze-pressing magnetic strip. Go into the groove of the PVC plastic strip. When pressing the yarn, you need to pay attention to pressing the yarn magnetic strip diagonally into the inside of the PVC plastic strip, and then press the outside, so that the gauze will be very smooth. Press the height-width first. -High-width sequential yarn pressing.

3. Cut off the excess screen

4. Install the assembled screen on the window

Attach the glued magnetic strip to the pressed screen. , wipe the window frame clean, leaving no dust, and keep it dry so that the adhesive-backed magnetic strip can better adhere to the window frame. First, peel off the protective film at the top and stick it on the top window frame. After fixing the position, gradually peel off the protective film on the left, right and bottom, and stick it on the window frame. Then press the magnetic strip firmly to make the adhesive stick tightly. on the window frame.

5. Install the clips

Remove the installed screen window, use the clips to mark 30% of the total window height, cut off the adhesive magnetic strip, and tear it off Remove the protective film on the back of the clip and stick it on the empty space, and then use 502 glue to put some glue on the inner corners of the installed adhesive-backed magnetic strip and the clip. This completes the entire process of DIY window screen making.

2. How to clean mosquito screens

1. Rinse with a watering can: Experienced people will introduce the method of cleaning the window screen with a watering can. Use a spray bottle to spray water while cleaning with a rag. You can use a spray bottle with high pressure, so that the impact force of the water is greater and the dirt is easier to rinse out. If the window screen can be removed, it can also be rinsed with a shower head.

2. Clean with a vacuum cleaner: Some people use a vacuum cleaner to clean window screens, and the method is relatively simple. Place a piece of newspaper outside the window screen. It is best to use the glass window outside the window screen to fix the newspaper. Don't let the newspaper run around. If that doesn't work, you can hold it with your hands. Then use a vacuum cleaner close to the window screen to suck out the dust and dirt bit by bit from the inside. The advantage of this method is that it is convenient and clean, and it also saves water while ensuring the floor is dry.

3. Clean with a sponge: You can use a sponge soaked with a small amount of water to wipe the window screen, which is easier to clean. This method shows good results. If necessary, you can try it. It will definitely make your window screens very clean.

The above is the installation and cleaning method of anti-mosquito screens. After the installation is completed, you must ensure that they are tight and clean them regularly, so as to best prevent mosquitoes. I hope the above content is helpful to everyone.