Let’s talk about the disadvantages of seaming agents and what is the correct way to use them?

Caulking agent is actually an upgraded version of caulking agent. It is used when laying ceramic tiles and floor tiles. As a decorative and practical decoration accessory, it is beautiful and The grouting agent improves the integrity and perfection of the final effect of floor tiles, so it is also loved by consumers. So, are there any disadvantages to seam sealant? In fact, the advantages of seaming agents are as prominent as the shortcomings of seaming agents. Below, the editor will tell you about the shortcomings of seaming agents and the correct way to use them.

What are the disadvantages of the beautiful joint agent?

The disadvantages of the beautiful joint agent 1. Construction defects: When the construction is completed, it must be inspected. At this time, it will be found that there will be Some uneven places, especially those with horizontal and vertical intersections, are difficult to smooth using this method.

Disadvantages of caulking agent 2. Appearance defects: Compared with the shortcomings of caulking agent, its wear resistance is relatively poor, and it can easily harbor dirt and evil. Especially for microcrystalline stone, polished glazed tiles, and vitrified tiles, their concave surfaces have very small gaps and cannot be bonded at all.

Disadvantages of the caulking agent 3. Performance defects: This product has insufficient adhesion and the tiles are not very smooth, so when the seasons change, gaps between the caulking agent and the tiles will easily appear. Cracked, peeled, peeled off. The caulking agent is not water-resistant and ages quickly.

Explanation on how to use and dosage of caulking agent

1. First, clean the brick joints. You can use a utility knife to remove the debris in the gaps. Be sure to do this when using it. Dry and dust-free.

2. Be sure to use a brush to clean the magazines in the gaps. Next, use a clean wet towel to wipe the tiles vigorously. In this way, debris and dust can be thoroughly cleaned.

3. When filling again, be sure to stick the textured paper neatly to both sides of the tiles, and then you only need to leave the construction area.

4. Use the glue gun to apply evenly into the gap. Please note that the force must be even. It may take several times of construction.

5. You can use a small scraper to scrape off the excess material. This will make the effect smoother, which will reduce the shortcomings of the existing seam agent.

6. Be sure to use a wet sponge to wipe away the spilled caulking agent.

7. Next, remove the masking paper. Remember to leave the masking paper on the tiles for a long time, which will also affect the construction effect.

8. After the construction is completed, if you are in summer, you need to leave it to dry for about two to three hours. The specific time will be determined according to the actual situation. It can be cleaned normally after about 12 hours.

9. High-quality construction technology can reduce the shortcomings of caulking agents, so there are strict requirements for construction personnel and skills.