What are the installation methods of shutter doors? What are the steps to install the shutter door?

After the shutter doors entered the China market, more functions were developed, such as electric shutter doors and crystal shutter doors. Of course, different shutter doors have different installation methods, so today Bian Xiao will tell you the installation method and installation steps!

First, the electric shutter door installation method

1. First, draw a line. Draw a line on the threshold to be installed according to the drawing. After painting, start to calculate the size of the shutter door and choose the appropriate shutter door. It should be noted that the height of the door frame is higher than that of the door leaf when drawing lines.

2. Second, fix the door frame. To fix the door frame, first remove the front fixing plate, reserve grooves on the ground on both sides of the hole, weld the iron foot of the door frame with the embedded iron plate, and then seal it with concrete.

Finally, just put the shutter door into the door frame. However, attention should be paid to the installation, and the connection above must be tight and firm to avoid safety accidents. When the two sides are connected, they should form a whole with the wall and ensure tightness. Then paint, you can test the use of the shutter door.

Second, the crystal shutter door installation method

1. First fix the motor on the motherboard, then fix the manual chain on the wheels and gears of the motor, and then shake the handle to test whether it will be reversed.

2. Then use a ruler to measure the main board and auxiliary board, mainly to see whether the size and specifications meet the specified requirements. Draw a horizontal line on the same axis, then punch holes in the horizontal line, and then fix the center of the first curtain of the rolling shutter door with the hole on the axis.

3. After the curtain sheet of the roller shutter is put on, both sides should be sealed with heads, then pulled with rivets, tied with ropes while punching holes in the curtain, then tightly connected the curtain with the shaft with a screwdriver, and finally leveled the curtain of the roller shutter to ensure the safety and rationality of the roller shutter. Then lift the shutter door back and forth to test its installation quality and safety.

Third, the installation method of fire shutter door

1, according to the design model, consult the product manual and electrical schematic diagram. Check product surface treatment and spare parts.

Measure the basic dimensions of each part of the product. Check whether the hole of the door is consistent with the size of the shutter door; Whether the position and quantity of embedded parts of guide rail and bracket are correct.

2. Measure the elevation of the hole and pop up the vertical lines of the two guide rails and the center line of the drum.

3. Weld the backing plate on the embedded iron plate, fix the left and right brackets of the drum with screws, and install the drum. After installation, the drum should rotate flexibly.

4. Install the reducer and transmission system.

5. Install the tying system of Dianshang Street.

6. No-load test run.

7. Install the pre-assembled curtain plate on the roller.

8. Install the guide rail. According to the position specified in the drawing, the guide rails on both sides and above are welded to the embedded parts of the wall and welded into a whole. Each guide rail should be on the same vertical plane.

9. Install the water curtain spray system and connect it with the master control system.

10, trial operation. Try it by hand first, and then use the motor to open and close it several times until there is no jam, block or abnormality.

Four, the shutter door installation matters needing attention

In fact, there are not many installation steps, but the installation should be very technical and experienced, so it is recommended not to install it yourself, and it is the best way to find a professional to install it. If you want to install it yourself, after all, there are many small details that will be ignored, or the installation is not accurate enough to fully guarantee its safety.