20 14 can the new sagitar stop immediately after running the expressway?

1. Load rejection: During the running-in period, the load capacity of the vehicle shall not exceed 75% of the rated load. When loading a new car, it should be less than the specified load or number of people, and it should not be overloaded, because overloading will increase the burden of the engine, transmission, transmission system, suspension system and other components, increase wear and tear, and cause damage to the vehicle.

2. Preheating before start-up: During cold start-up, it is best to wait until the water temperature is preheated to above 50℃ before starting up. When you start, you should lightly step on the slow clutch and throttle, and choose a good road to drive. Don't step on the gas when the car is cold.

3. Choose high-quality lubricating oil: Choosing low-viscosity and high-quality lubricating oil can make the friction surface get good lubrication and slow down the wear of parts.

4. Speed needs to be controlled: during the running-in period, the speed must be controlled well, not too high. When the speed is controlled at 50~80 km/h and after driving 1500 km, the speed and speed can be gradually increased to the maximum speed allowed by the vehicle, so as to ensure that the loads of important components such as pistons and cylinders are increased in a relaxed state.