Novice driving skills shift

First, put on the first gear, easily clutch, start the car, release the handbrake, add a little throttle, and gradually loosen the clutch. Forward, when the engine speed reaches about 1800-2000, step on the clutch and shift to second gear. Then step on the clutch when you are in gear, don't step on the accelerator, step on the clutch slowly, and gradually fill the door to make the vehicle run smoothly. Finally, when turning, in the case of high gear, first step on some brakes to slow down, and then use inertia to turn, or slow down first and then shift gears. Don't step on the clutch to shift gears. According to the road conditions and general conditions, the brake should not be fully depressed. Slow down and step on the clutch to shift gears. In case of emergency, brake directly to the end. Shift and shift mode: 1. Operation essentials of clutch and throttle: If the clutch and throttle are not well matched during automatic start, the engine will stall or shake during automatic start. The power of the engine is transmitted to the wheels through the clutch, and the distance to the clutch pedal is only the upper and lower lcm. Naturally, after the clutch pedal is engaged, lift the clutch pedal until the clutch friction plate starts to contact. In this position, the foot should be suspended and the valve should be filled with water. After the clutch plates are fully contacted, completely lift the clutch pedal. This is "two fast and one slow", that is, the speed of lifting the pedal is slightly faster at both ends and slightly slower in the middle; 2. Two-foot clutch operation method: When shifting gears, the two-foot clutch shift method should be used regardless of whether the high gear is shifted to the low gear or the low gear is shifted to the high gear. When changing from low gear to high gear, first step on the clutch pedal to be quick and agile, and at the same time release the accelerator pedal. Then shift the gear lever to the neutral position, quickly lift the clutch pedal, and then step to the bottom. At the same time, hang the gear lever to the high position, lift the clutch pedal and fill the gas door. When the clutch plates touch, pause for a moment. After the clutch plates are fully contacted, completely lift the clutch pedal. 3. When shifting from high gear to low gear, first step on the clutch pedal with quick response, at the same time relax the accelerator pedal, put the gear lever in neutral position, and quickly lift the clutch pedal. At the same time, quickly add a pedal and immediately relax the accelerator pedal (refueling means increasing the engine speed to drive the transmission drive gear), then quickly press the clutch pedal and shift the gear lever to a lower gear. The whole reaction should be rapid, compact and accurate; 4. Purpose of using two-foot clutch operation method: When shifting from low gear to high gear, the purpose of using two-foot clutch operation method is to make the rotation speed of the intermediate shaft (and the first shaft) consistent with the rotation speed of the second shaft of the gearbox. When shifting from the high gear to the low gear, the two-foot clutch operation mode is adopted to make the rotation speed of the intermediate shaft of the gearbox coincide with the rotation speed of the second shaft of the gearbox, so as to prevent collision and noise caused by inappropriate gear rotation speed during upshift or downshift. This will not only make the vehicle shift smoothly, but also prolong the service life of the parts. Note: To increase the engine speed by adding empty oil, it is necessary to master it properly according to the driving speed, so that the engine speed is consistent with the vehicle speed, and the coordination must be consistent, otherwise the transmission gear or synchronizer will make noise.