Beginners learn how to drive a manual car.

Sitting posture is the most important in manual driving technology, because the waving of hands requires close cooperation between hands and feet, and the coordination of operating surnames is particularly important, especially when you use some advanced operating skills. Only the correct sitting posture can ensure the coordination of this operation. In addition to sitting posture, here are some suggestions for everyone:

First, how to set the correct sitting posture

1. The distance between the steering wheel and the body is based on the back close to the back of the chair, and both hands and wrists can touch the upper edge of the steering wheel;

2. Step on the clutch, the knees should be slightly bent, and the back should be close to the back of the chair;

3. After adjusting the sitting posture, repeatedly operate the clutch and gear to see if there is any problem, and then make fine adjustments.

Second, throttle control.

In fact, it is an exercise for the sensitivity of the soles of the feet. Whether your car can become a part of your body in the future, your sole has the most say.

First, stop the car and put it in neutral, give oil and see if you can fix the speed at a certain speed. After proficiency, you can practice this step while driving, and then practice this step in the first gear, because the first gear transmission ratio is large (like the power arm length of a lever), the sensitivity of the throttle is the highest, and the control is not easy.

Third, shift gears.

Gear shifting is a manual action to change the transmission ratio of gearbox to adapt to different road conditions and driving performance. Taking downshifting as an example, it is suitable for overtaking and downhill (engine braking); Upshifting is suitable for high-speed driving, reducing vehicle speed and engine load.

There are two common mistakes when operating the gear lever:

1. The club head is held too tightly, resulting in stiff gear shifting and even wrong gear shifting. The correct way is to hold the club head lightly, as long as the strength does not cause the club head to slip.

2. The shift action is too urgent. Of course, the faster the shift, the better, but if it is too fast, it is easy to get into the wrong gear. Therefore, no matter how fast it is, it is necessary to stop in neutral and let the wave rod return to the center as a reference for the next gear. This is the best way to avoid entering the wrong gear. When you are familiar with this shift mode, it will not have much impact on the shift speed.

Fourth, the clutch

It is mainly composed of a group of friction plates, which are located between the engine and the gearbox and transmit the power of the engine to the gearbox. Usually step on the clutch pedal quickly and slowly, otherwise it will cause great loss to the clutch. Sometimes when the vehicle speed is particularly slow, the clutch will enter a semi-clutch state and send part of the power to the gearbox to adapt to the slow vehicle speed. But this method directly causes loss to the clutch, and it must not be done unless it is necessary.

Summary:

1, three things to get on the bus: adjust the distance between the seats and the height of the steering wheel; Adjust three rearview mirrors; Fasten your seat belt.

2. Starting action: Step on the clutch, step on the foot brake, release the brake, check whether the gear is in neutral, light the ignition, put in the first gear, release the foot brake, slowly lift the clutch, and at the same time lightly step on the accelerator until auto start Quan Song clutches.

3. Shift action: release the throttle, step the clutch to the bottom at the same time, shift the gear to a gear suitable for the vehicle speed, lift the clutch at a suitable speed according to the gear, and lightly step on the throttle at the same time; Upshifts and downshifts are the same.

4. Braking action: Press the brake hard properly, and press the clutch to the end before the car comes to a complete stop.

5. Parking action: After the car stops completely, put the gear into neutral, pull the handbrake, release the foot brake, release the clutch and turn off the engine.