Pull Skills of Badminton Battery

Drawing skills of badminton racket 1, measure the length of the line with the racket.

The vertical line is eight beats long. Firstly, the vertical strings are evenly pulled from the middle point of the racket head to both sides to ensure the consistent deformation and elastic symmetry of the left and right sides of the racket.

Steps:

The vertical line should pass through the 1 hole on the racket head and be pulled symmetrically to both sides in turn. Clamp the two wires at the top and middle of the racket frame with a wire clamp. Then add another pound of cable. Fix the weighted line with another clip, and pull the other clip at the same time, loosen the middle clip and move to the newly pulled line.

Here's a detail. After pulling the second thread, you can directly pull the subsequent thread. You can also re-weigh the first string and adjust the clip to the top of the racket frame to ensure the balance between the left and right pounds. When re-weighing, don't use too much force, because the thread has been tightened.

Turn the beat around and it will be easier. Tighten the lines on the left and right sides in turn.

When you go through the bottom 9 holes, you must jump to the bottom 12 hole and then go through it (skipping two threaded holes in the middle), go through the top 1 1 hole, go through the top 10 hole, go through the bottom 10 hole and jump back to the bottom 8 holes to cross the knot. Over. Special note: the vertical string 10 is the last vertical string pulled, not the vertical string 1 1.

2. Make six and a half beats a horizontal line.

Horizontal chords should be pulled one by one from the frame head to the frame bottom, and the number of pounds of horizontal chords should be increased by 2 pounds on the basis of the number of pounds of vertical chords.