Can the top two and the last four dumpers get blue cards now?

The new policy of blue brand dump truck: the structural layout of light trucks should meet the following technical requirements: 1, and the tire load should not exceed 1.4 times of the total mass. The nominal cross-sectional width of the tire is less than 7.00 inches or less than 195 mm; When the rear wheel adopts a single tire, the nominal section width of the rear wheel shall not exceed 265 mm (metric). 2. Engine (diesel) displacement: less than 2.5L; Refrigerated trucks under 3.0L). 3. Interior width of trunk: 2 100mm or less (dump truck 1800mm or less). The load-bearing quality utilization coefficient of light trucks (excluding new energy vehicles) shall meet the following requirements: the rear compartment of light trucks with a grating with a total mass of more than 3500kg shall adopt a multi-layer grating structure (except that the maximum distance from the bottom of the cargo compartment to the top of the grating is not more than 1.500mm); The floor (a plane that runs through the whole luggage compartment and is parallel to the floor of the vehicle luggage compartment and physically divides the luggage compartment into one or more spaces) must be unified, reasonable and non-detachable. Fourth, the rear wheel of dump truck adopts single tire structure, and the total length of the vehicle shall not exceed 5000mm ... Except dump truck, the chassis of dump truck shall not be used for ordinary grille type, pad type, barn type and flatbed car.

The structural layout of the first two paragraphs and the last four paragraphs of light trucks shall meet the following technical requirements: for light trucks with a displacement of more than 2.5 liters in the announcement, if it is required to produce products that meet other requirements in this notice, a six-month production and sales transition period shall be given. Implement the main responsibility of product safety, quality and production consistency of production enterprises: it is strictly forbidden to issue factory certificates of different announced models to the same vehicle, and it is strictly forbidden to issue factory certificates of complete vehicles to vehicles that fail to pass the inspection and do not meet the requirements of production consistency.