How to Check XA6 132 Universal Lifting Table Milling Machine

1, pre-shift maintenance:

Check the important parts.

Wipe the exposed rail surface and lubricate all parts as required.

Idle and check whether the lubrication system is normal. Check the oil level, the oil level shall not be lower than the oil mark, and fill all parts with lubricant.

lube oil

2. Maintenance after work:

Do a good job in cleaning beds and parts, and clean up iron filings and surrounding environment.

Wipe the machine tool.

Cleaning agent, clamp, measuring tool.

All departments return to their positions.

Second, the regular maintenance of each part:

1, bed and appearance:

Wipe the workbench, lathe bed guide surface, screw, machine tool surface and dead angle, operating handle and handwheel.

Deburring of guide surface.

Clean, no oil.

Remove the cleaning felt and remove impurities from the iron sheet.

Remove the rust of all parts, protect the painted surface and avoid collision.

The guide surface, sliding surface, handwheel handle and other exposed parts that are easy to rust of all components shall be

Cover with oil.

2. Spindle box:

Clean and well lubricated.

The transmission shaft has no axial movement.

Clean and change the oil.

Replace worn parts.

Check and adjust the tightness of clutch, lead screw, insert and pressure plate.

3. Worktable and lifting platform:

Clean and well lubricated.

Adjust the clamping belt gap.

Check and tighten the screws of the platen of the workbench, and check and tighten the screws and nuts of the operating handle.

Adjust the nut clearance.

Clean the hand oil pump.

Remove the burr on the surface of the guide rail.

Repair or replace worn parts.

Clean and adjust the workbench, screw handle and column insert.

4. Gear box of workbench:

Clean.

Good lubrication.

Clean and change the oil.

The drive shaft is not moving.

Replace worn parts.

5. Cooling system:

All parts are clean and the pipes are unblocked.

There is no precipitated iron powder in the cooling box.

Clean the coolant tank.

Replace coolant.

6, lubrication system:

Lubricating oil is added to the nozzle, guide surface, screw and other lubricating parts of each part.

Check the oil level of the spindle gear box and the feed gear box, and add oil to the elevation position.

Clean oil, smooth oil circuit, effective linoleum and eye-catching oil label.

Clean the oil pump.

Change the lubricating oil.

Tengzhou Dongyue Machine Tool Factory hopes to help you.