How to clean the lint picker?

Wool bonding device is very practical in our daily life. It can not only remove the wool balls from our tweed coat in winter, but also clean the fine dust stuck on fabric products such as sofas, sheets and quilts, so that there is no flying dust at home. So how should the hair adhesive be cleaned and used every day? Let's study together.

How to clean the lint picker?

1, wash by hand first, and then rinse with running water.

2, use a razor, only a few dollars bought in the supermarket, can also be used to shave all the hair balls on the clothes.

3. Dip it with wide adhesive tape.

How to use the hair clipper

Hair sticking device is a tool for removing dust and hair from clothes, sheets or other articles. There are two main types, one is a tearable hair adhesive, and the other is a water-washing hair adhesive.

1. When using the tearable wool gluing device, tear off the film on the surface first, and the adhesive surface of the adhesive tape will be exposed, so that you can roll back and forth directly on the surface of the clothes until the things on it are basically glued; After a period of use, tear off the used layer outside.

2, the use of water washing is the same, but after use, it is washed with water and can be used repeatedly. Their characteristics are: high tear viscosity, and can not be washed several times, the viscosity is greatly reduced. Washing is cheap and expensive.

3. The tearable hair sticking device can't completely stick away the scraps of paper at one time, but needs to roll repeatedly. It takes about 30 layers of paper to bond the whole trousers. However, this kind of single bing has a disadvantage, that is, the roll paper will automatically roll out, so just buy the handle in the middle to fix the two sides. The viscosity of the washable roller is better than that of the tearable roller, and the tearable wool sticking device will still leave white spots, so that the washable roller can be stuck off. But! ! ! One side of trousers is about 1/2 non-sticky, and it will stick only after washing and drying.

Steps of self-made wool sticky device

1, brush removal

You know, the kind that is often sold on the roadside. I don't have a brush at home, but I read hundreds of comments on Taobao, and the conclusion is that it is similar to the tearable one, with good viscosity, but it needs manual hair removal. If you use it too much, it will have floating hair and be unclean.

2. Prepare a paper tube.

It's the shaft in the middle of household plastic wrap, so you need to leave a layer of plastic wrap. Evenly cut 12 small openings at both ends of the paper tube with a carving knife, each small opening is cut by 0.5 cm, and the interval between each opening is 1 cm.

3. Stretch the rubber band on the paper tube

Put the rubber band in two adjacent positions, and stagger the other end by one grid. A * * * requires all six rubber bands to be tied. Tie the rubber band in the opposite direction in the same way. After binding, the whole thread is interlaced into a net, thus completing a hair sticking device. If there is too much hair on the hair sticking device, just take off the fine hair wrapped on it and wipe the roller of the hair sticking device with a wet paper towel. Therefore, it can be reused.