How much does it cost to install the elevator?

Elevator is a kind of vertical elevator powered by motor, equipped with box-shaped pod, which is used to transport people or goods in multi-storey buildings. There is also a step, the pedal is installed on the track and runs continuously, commonly known as escalator or moving sidewalk. Fixed lifting equipment serving designated floors. The vertical elevator has a car, and the car runs between at least two rows of rigid guide rails with vertical or inclined angles less than15. Let's take a look at the steps and methods of installing the elevator and how much it costs.

Steps and methods of elevator installation

1, elevator installation method

According to the actual situation, we use the method of tower crane to install on the construction site, that is, use tower crane to install the elevator foundation frame, the first three standard sections, the foundation fence, the hanging cage and the drive plate. , and then increase the installation section until it reaches the use height.

2, the elevator installation steps

(1), installation of foundation structure (foundation) Lift the elevator foundation structure on the elevator foundation with a tower crane, level the standard joint with a spirit level (ruler), fill the gap between the frame and foundation, and then tighten the anchor bolts.

(2) Installation of guide rail frame (standard section) Assemble the bottom three sections on the ground, and then hoist them to the interface of foundation frame with tower crane. Wei Yi will adjust the verticality (11000), tighten the connecting bolts, and the tightening torque will be 350N.M Quotation for construction elevator accessories After the elevator base and foundation section are installed, they can be assembled.

④ Installation of ladder cage

After installing six buffer springs on the frame, lift the ladder cage with tower crane, and slowly put it on the standard section and on the buffer springs.

(5) Installation of driving device

Release the brake on the motor: First, remove the two cotter pins. Before disassembly, make a mark on the nut opening so that the two nuts can be tightened after reset. Make sure to rotate the two nuts down in parallel until the brake is released, and you can pull the brake disc at will. You can also use a wedge to open the motor brake device to release the brake.

Lift the driving device with a tower crane, take the position from above the standard section, aim the driving device at the connecting lug plate of the hanging cage, insert the pin shaft and fix it (the elevator with overload device inserts the induction pin, the stop groove faces upwards, and then install the fixing plate). After the driving device is hoisted in place, restore the performance of the motor braking device and install the cage top guardrail.

Precautions for installation of construction elevator:

1. Construction elevator drivers must receive special safety technical training, pass the examination and hold relevant certificates. Strictly work after drinking.

2. The driver must be familiar with the performance, structure, maintenance and repair knowledge of the operated elevator, and fill in the mechanical resume and required reports in time as required.

3. Flammable and combustible articles and other sundries shall not be piled up within 5m around the construction elevator, and ditches, pits and grooves shall not be dug within this range. A protective shed should be set at the ground feed inlet of the elevator.

4. When repairing the ladder cage, if the weight of the ladder cage is lower than the counterweight after removing the parts, the ladder cage must be locked on the guide rail frame.

5. It is forbidden to use the boom of the construction elevator to support cable slogans and other items unrelated to the elevator.

6. The tower crane or other hoisting machinery constructed in the same site shall keep a distance of more than 5m from the construction elevator, and have reliable anti-collision measures.

7. After the installation of the construction elevator, it must be accepted by relevant personnel before it can be put into use.

How much is the elevator?

If installed, mainly consider two pieces: civil engineering and elevator equipment.

Materials and labor for civil engineering expansion may be submitted to the Ministry of Housing and Urban-Rural Development for approval, which is about 10W.

Elevator mainly includes purchase, installation and approval. 1.3 million low-grade domestic elevator is ok, the floor is not high, not too good. Later maintenance companies can find better ones.

The price depends on what kind of ladder you use. Generally speaking, if it is a residential building, you can choose the installed sightseeing ladder, which is transparent on three sides. Sightseeing ladders are generally a little more expensive than ordinary ladders, but not too expensive. 800kg, 1.5m/s, standard. The equipment price is about 6,543.8+0.35 million, including installation and other expenses, which is about 6,543.8+0.8 million.