How to locate the charging station of battery car?

From the point of view of electric vehicle users, charging piles should be installed in places with dense electric vehicles and concentrated charging needs, such as schools, communities, hospitals, factories, shopping malls and other centralized parking lots. At the same time, try not to install in the basement. First, it needs to be equipped with fire safety facilities. Second, it will affect the communication signal of the charging pile. Besides, these golden rules must be observed.

Article 1, waterproof requirements:

The local drainage system installed in the charging station should be kept unobstructed and should not be located in low-lying places and places where water may accumulate. Rainwater is collected through intercepting ditch or rainwater outlet and discharged into municipal rainwater system. When there is no centralized drainage condition, it is necessary to ensure that the charging pile will not be flooded. There are many kinds of charging pile products, especially those that directly contact the ground. Once water touches sensitive components such as circuit boards, people may get an electric shock if they are not careful.

Article 2, fire prevention requirements:

The combustion performance, fire resistance limit of building components in the charging station, and the fire prevention distance between buildings (structures) in the station and civil buildings (structures) outside the station shall comply with the provisions of Class C workshop in GB 500 16-2006 or GB 50229-2006. Flammable and explosive sundries shall not be piled around the charging pile, and attention shall be paid to stay away from fire sources to eliminate potential safety hazards. The charging station is equipped with a power emergency stop button, and the emergency stop button logo is affixed.

Article 3, anti-collision requirements:

Vehicle limiters, anti-collision columns (bars) or anti-collision warning lights should be set around the charging facilities and equipment; A sufficient distance should be kept between the charging pile and the rear of the charging vehicle, not less than1m. In addition, the distance between sockets for installing charging piles is 60-70cm, so as to ensure that the push and pull of adjacent electric vehicles will not affect another electric vehicle.

Fire protection has safety standards for charging piles, and there are also site selection and installation standards for charging piles. You'd better find a professional to follow up and inspect the site when installing charging piles or selecting sites.