20 14 Dongfeng Honda civic car manual

Hello! First of all, we should know about the transmission gear lever of automatic transmission, which is equivalent to the gear lever of manual transmission. Generally, there are the following gears: P (parking), R (reverse gear), N (neutral gear), D (forward gear), S(or2, which means 2nd gear), L(or 1, which means 1 gear). The use of gears is very important. Let me introduce it to you. How to operate an automatic car? P- When parking, you need to put the car gear in this position. Simply put, if you need to put the car in one position for a long time, you must pull the handbrake and push the pole position to the P position. It must be noted that the car must stop before it can use P gear. Otherwise, it is easy to bring unnecessary burden to the engine and cause damage. The automatic car is also equipped with a neutral start switch, which only allows the car to ignite and start the car in the P or N gear to prevent the car from jumping out suddenly when it is started by mistake in the stopped state. R- reverse r is reverse. Generally, it is necessary to press the safety button device on the shift lever and put the shift lever in the R position. Note that you can't use R gear when the car is moving forward, but only when it is parked. Remember this! N- neutral neutral n is equivalent to neutral, which can be used when starting or towing. When waiting for a signal or in a traffic jam, you often keep the shift lever in the D position and brake at the same time. If the time is short, it is ok to do so, but if the parking time is long, it is best to shift to N gear and tighten the handbrake. It should be noted that in order to save fuel, some drivers will slide in N gear when driving at high speed or downhill, which is easy to burn out the transmission, because at this time, the output shaft of the transmission rotates at high speed, while the engine is idling, the oil pump is short of oil supply, the lubrication condition deteriorates, and the transmission is easy to burn out. This situation is not uncommon, and everyone must pay attention. D- use of forward gear d (forward gear). When driving normally, the car can shift gears automatically when the gear selector lever is placed in the D position. D position is the most commonly used driving position. What needs to be mastered is that the acceleration performance of a car is different from that of a car, but the most basic thing is to tread lightly! If you finally step on the accelerator, the forced low switch will automatically downshift, and the car will accelerate quickly, which is easy for novices to control badly. So be sure to slow down carefully and control it at will after you know the performance of the car. The use of S, L- low gear The automatic transmission is in the low gear range in the S or L position, and can be used in situations such as ramps. Switching to S or L can play the role of engine braking when going downhill, but when switching from D to S or L, the vehicle speed should not be higher than the corresponding upshift speed, otherwise the transmission will be damaged. In addition, in rainy and foggy weather, if the road surface adhesion conditions are poor, you can also shift to S or L and drive at a low speed. Don't use a gear that can automatically shift gears to avoid the car slipping. At the same time, it must be remembered that when slipping, you can push the shift lever to the N position to cut off the power of the engine and ensure driving safety.