Safety facilities of stamping equipment

1. Stamping equipment shall have nameplate, various operating instructions and safety and warning instructions.

2, power wiring should be standardized, the cable of the equipment should not be damaged, to prevent aging.

3. The door lock of the distribution box on the stamping equipment should be equipped with a key, and the power supply will be automatically cut off when the door is opened.

4, single, continuous, pedal stamping and other operations should be used with a key lock switch.

5. When the stamping equipment runs in a single stroke, there should be no continuous stamping stroke.

6. When continuous stroke operation is selected, there should be a pre-control action link in the operation process.

7, stamping equipment must have an emergency stop button, and should be able to self-lock.

8. There should be interlocking control between pedal operation and manual operation.

9. For transmission parts such as transmission gears, pulleys, flywheels and levers exposed outside the fuselage and at the top of the fuselage, protective covers should be installed.

10. The pedal device is pedal-operated, controlled by an electric switch, and can be automatically reset.

1 1, the upper and both sides of the pedal should be covered with protective covers, and the pedal should be non-slip.

12. Stamping equipment must have safety protection measures to prevent hands from entering the closed area of the mold. Users should take safety measures such as automatic loading and unloading, installing safety protection devices, safety molds and using special tools to take and feed materials according to the type of stamping equipment and the shape of the workpiece produced.

13. Three tests (protective grounding, insulation and withstand voltage tests) of the electrical system shall be conducted regularly, and test reports shall be provided.

14. Each stamping equipment shall obtain a safety license for stamping equipment, which shall be within the validity period.