How to set the uplink and downlink of the mobile phone?

Question 1: How to set the wlan uplink and downlink 1, and the address fields of 20m optical fibers for one computer and two mobile phones?

There is an option similar to "DHCP address assignment" in your router, which will list the IP address assignment range of this router, which is generally192.6438+068.1.2 ~192.38+068.438+0.2. 4666437

The IP address field in the line speed page is192.168.1.2 ~192.5438+068.1.254. Consistent with the above, ensure that all PCs are within the management scope of line speed rules.

The following "port", "protocol" and "priority" are all empty, and nothing needs to be filled in.

2. Bandwidth setting

You'd better confirm whether your router sets the bandwidth at K bps or K Bps. It should be K bps.

1M bandwidth means 1M bps,1Mbps =1024kbps =128kbps.

The maximum and minimum bandwidths of uplink and downlink can be set to be the same, or 1024 or 128. It depends on whether your router uses K bps or K Bps.

Question 2: What do the uplink and downlink of mobile phones mean? Refers to online data, uplink refers to uploaded data, and downlink refers to data downloaded to your mobile phone. If it is helpful, please adopt it. For your mobile phone, click Satisfied in the upper right corner. Thank you! !

Question 3: How to set the uplink speed and downlink speed of100M broadband? Is there any software that can set this for three mobile phones?

Question 4: The mobile phone only has an uplink, not a downlink. Dear Samsung users, hello:

According to your description, we suggest you try the operation according to the following steps: 1. Under the standby desktop-click Application-Settings-More Networks-Mobile Networks-Network Operators-Search Networks-Select the network operators supported by your SIM card 2. Take out the SIM card and clean the metal contacts of the SIM card with rubber. (Is the sim card in poor contact? ) 3. Try to replace the sim card (Is the SIM card aging or damaged? ) 4. Check whether the mobile phone is equipped with software such as security guards or incoming calls, uninstall it and try again. 5. Back up mobile phone data (phone book, SMS, multimedia files, etc.). ) and restore the factory settings. If the problem still exists, it is recommended that you send your mobile phone to the nearest Samsung service center for testing and maintenance. Please click on the following Samsung Service Center equipment link: Support-. Samsung/Support/Service Location. ASP suggests that you apply for "booking to the store" in Samsung official website to enjoy priority maintenance service: please bring your machine, invoice and warranty card to the service center you reserved on time after support.samsung/pre-booking's appointment is successful.

If you need help, please visit support.samsung, and official website will provide you with multi-channel service support!

Question 5: There are uplink rate and downlink rate in my mobile phone network settings. What do you mean? Uplink rate is upload speed or an index related to upload speed.

Downlink rate is download speed or an index related to download speed.

The higher the speed, the faster the speed.

Question 6: How to set the upstream bandwidth and downstream bandwidth for router speed limit? First, the total bandwidth needs to be set to 10240K, that is, the download rate of 10M bandwidth. Then set the speed limit, limit the maximum bandwidth of each IP to 2048K, and leave the last IP to ensure the minimum bandwidth of 2048K for your own use.

Question 7: Mobile phone wifi has uplink signal, but no downlink signal. According to your description, I suggest you:

1. Check whether other devices can surf the Internet through this WIFI.

2. If not, please log in to the router to see if your route can dial normally.

3. If the router is set correctly, please use a stand-alone computer to directly connect to the network (that is, whether you can surf the Internet normally without routing test).

4. According to the above situation, judge whether to repair the external network or replace the router.

Question 8: How is it that the mobile phone traffic is turned on with only the up arrow and no down arrow? Hello:

According to the situation you described, please follow the following methods:

1. Turn off the data connection function and turn it on again.

2. If only the up arrow is displayed without the down arrow when logging in to the browser or other networking software, please operate: Settings-More-Mobile Network-Access Point Name-Menu Button (the button to the left of the HOME button)-Reset to the default value.

3. If the same situation still occurs and you can't surf the Internet normally, please try to create a new surfing parameter. Operation: Settings-More-Mobile Network-Access Point Name-Menu Key-New APN

Name: fill in APN at will: cmnet/cmwap/3gnet/uniwap (according to the access point of sim card).

Agent: 10.0.0. 172 Port: 80

No other settings are required. Click the menu key-Save, and then select a new APN name.

4. If the data connection icon still only has an up arrow, please back up the data in your phone (such as contacts, text messages, photos, videos, etc.). ), and then restore the phone to the factory settings. Operation: Setup-Reset-Return to Factory.

If the mobile phone still can't access the Internet normally after the above operations, please bring the purchase invoice and three-guarantee certificate to Samsung Service Center for inspection.

Samsung service center address inquiry:

support.samsung/servicelocation

Welcome to Samsung Electronics official website for more information: support.samsung