Traffic control sent a message that there was no photo for running a red light.

Read the traffic light signal. If the traffic light signal is in a red light state, the camera will start the snapshot mode. The vehicle wheel overturns the loop of the coil or enters the virtual coil of the camera, and the camera starts to take photos as the first evidence photo. At the same time, the system will automatically analyze license plate information. At this point, the vehicle is crossing the line. When the vehicle crossed the stop line, the camera once again captured the photo of the red light running process as the second evidence photo. After the vehicle crossed the line and continued to drive through the intersection, the camera finally captured the photo of running a red light as the third evidence photo. Judging from the process of the above-mentioned electric police capturing the red light, there are several possibilities for not receiving the violation information:

When you run a red light, the control system of the traffic light signal system fails to link the camera in time, that is, it is in a fault state, and the camera will not take all the pictures. The capture camera is in a fault state, and there is no capture or the image captured by the camera is very blurred. It takes three photos to run a red light, and your vehicle only took 1-2, which does not constitute a violation of the law.