NETGEAR router reset operation guide

In case of firmware upgrade, abandonment of current configuration, configuration confusion, abnormal equipment or technical support requirements, you may need to reset. This paper will introduce the reset methods of NETGEAR router, including hardware reset and soft reset.

Hardware reset

Hardware reset is a way to reset the router. The specific steps are as follows: 1. Locate the reset button on the router, usually located on the nameplate on the back or next to the network cable connector. 2. Turn it off for a few seconds before turning it on, and then wait for a minute or so. 3. Press the reset button with a needle, pen tip, toothpick, etc. Hold for 15 seconds until the indicator light changes, and then release the indicator light. 4. The router will be restored to factory settings within two minutes without manual intervention.

Soft reset

Soft reset is another way to reset the router. The specific steps are as follows: 1. Enter the management interface, find the "Erase" option and confirm. 2. The equipment will automatically restore the factory settings within 3 minutes without manual intervention.

Matters needing attention

Do not perform any operation on the device during the reset operation, including disconnecting the power supply. In addition, the reset operation will clear all configuration information, including user name, password, network settings, etc. Please be careful.