How to set the information indicator of iPhone?

The turn-on mode of the iphone SMS reminder light is shown in the following figure:

1. Find the "Settings" option in the main menu page, and then click the "Settings" icon to enter the settings page;

2. Find the "General" option on the "Settings" page, and click the "General" option to enter the operation page;

3. Find the "Accessibility" option in the "General" option page and click to enter the "Accessibility" operation page;

4. Find the "LED flashing to remind you" button in the "Accessibility" option, and click Enter;

5. Check whether the button behind "LED flashing reminder" in "LED flashing reminder" is turned on. If it's not open, open it. If it is open at first, please close it and then open it again.

Extended data

Iphone phone water treatment method:

1. First of all, be careful not to turn on the power at this time. If it was on before, turn it off quickly.

2. Then remove the covers such as the iPhone case.

3. Take out the SIM card and blow dry it immediately, and then wrap it in paper.

4. All exposed interfaces, such as earphone plugs and docking station connectors, are plugged with tiny cotton swabs or paper towels and sucked dry. Both places are equipped with immersion display lights, which will turn red after self-inspection. It's easy to hide stagnant water here, so pay attention to suck up the water here.

5. Wrap the fuselage with a towel or paper towel with good water absorption to absorb water. Never use the method of throwing. The shaking will make the water that has entered the fuselage disperse and touch the parts that can't touch the water, which will lead to worse results.

6. Finally, observe the LCD screen and camera to see if there is fog. If there is, you can wrap the fuselage with paper towels and put it in a sealed bag. At the same time, you can put the desiccant commonly used in snacks, try to evacuate the air and seal it.

7. Then put the whole iPhone in a slightly hot place, such as AC power supply and computer heating. Be careful not to put it in a high heat environment, and you can't always blow it with a hot air cylinder, which will damage the internal components.