What is the monitoring error code 10007?

? You can see if there is any fault analysis in the manual according to the code. If not, you can contact after-sales or official customer service for consultation, so that you can judge the specific fault according to the code information.

Speaking of surveillance, it's already a rotten street. Shops, communities and families are all equipped. They are happy when they are installed. When the fault happens, they underwrite it, after-sales insurance ends, and the family asks for money. They don't understand that lovers are quite expensive. Today, I'll tell you the solution to the monitoring fault. The following content does not involve a new installation, but only the solution after the installation is completed for a period of time.

Troubleshoot the camera first, because once the hardware is broken, non-professionals will talk nonsense. Unless you really have strong hands-on ability and like to study hard, just have fun. Say the lines first. If the camera is powered by non-POE, there are at most two wires, a network cable and a power cord at the front end.

If the network cable fault is more than five types of network cable (non-integrated cable: a cable has both network cable and power cable, which can be understood as that the network cable and power cable are wrapped together with a sheath), then once the fault occurs, we will take down the faulty camera to see if the network port is rusted or not, and see if the copper sheet of the crystal head and each core of the network cable are in good contact.

In fact, although the network cable has 8 cores, among the five types of network cables, only 4 cores can be used to transmit monitoring data (non-POE).

For cores 1, 2, 3 and 6, as long as the four cores are in good contact, the other four cores are unobstructed even if they are not connected to the network. Therefore, sometimes, when monitoring the installation with the integrated line, the integrated line with 4 cores +2*0.75 will be selected. In fact, it is best to choose an 8-core network cable when wiring initially. If the network cable breaks after wiring.

Another core can also solve the problem. If it is a four-core network cable, it will be finished if one core is broken. This is the connector end. Except for the disconnection in the middle, we can look at all the network cables. After reading it, I found that the connector performed well, so we'd better have a cable calibrator.