Etc correct installation location solution video

The correct installation location of ETC is as follows.

1, with a height of not less than 1.2m and not more than 2.5m ..

2. The installation angle n should be between 30 ordm and 90 ordm (the angle between the surface of the electronic tag and the horizontal plane).

3. OBU equipment for small vehicles (such as cars and vans) is installed in the middle and upper part of the front windshield and used in the middle and lower part of large vehicles (such as trucks and buses).

4. If the vehicle itself has an explosion-proof membrane or the explosion-proof membrane is attached later, the explosion-proof membrane contains metal ions, which will affect the signal transmission of the microwave communication link, so it should be installed in the "microwave skylight" tape, or a rectangular area of 8cmX 10cm should be opened for the explosion-proof membrane.

5. If the car glass is too thick or modified, it may lead to signal transmission failure of ETC equipment. At this time, it is necessary to find a professional in the repair shop to solve it.

Finally, I want to remind you that if the OBU equipment is dismantled or moved without authorization, the OBU has no electricity, and the ETC electronic tag falls off or loosens, the ETC electronic tag may become invalid. You can take the ETC device to the bank or highway office that handles the ETC card for testing and reactivate it, because the adhesive has loosened. Pay attention to the ETC electronic tag you got, which is moisture-proof, waterproof and antimagnetic.