Flower arrangement method of roses

A complete collection of rose flower arrangement methods

Roses like sunshine, cold and drought tolerance, and loose and fertile loam or light loam with good drainage. The following is the arrangement method of roses I arranged for you, hoping to help you.

The flower arrangement method of roses: prolonging the flowering period

Adding half a piece of ground aspirin, or a piece of vitamin C, or a proper amount of boric acid, sulfur or 0. 1% salt to 500 grams of water can prolong the flowering period.

Rose flower arrangement method: salt water or sugar water cultivation method

Adding a little salt or sugar to the water for growing flowers, or crushing the wound when the flowers are just cut, and rubbing with salt, is better than blanching. Sugar can make flowers bright and lasting. But the branches with buds should not be soaked in salt water, otherwise the flowers will be difficult to open.

Rose flower arrangement: rational use of water

It is the key to prolong the life of flower arrangement. Use clean river water, rainwater or pond water near room temperature when arranging flowers. If tap water is used, it must be stored in a cylinder (barrel) for 1 day before use. At the same time, we should pay attention to changing water frequently, and remove the residual flowers and leaves in time, and trim the flower branches appropriately, so as to facilitate the absorption of water and prolong the life of flowers.

The flower arrangement method of roses: preparing sterile solution

Adding 1% alcohol and 0. 1% sugar and inserting flowers into this solution can also prolong the flowering period.

The flower arrangement method of roses: pruning

It is suggested to cut off some leaves in the water at the end of morning dew to prevent rot, and insert them into the water immediately after cutting to avoid affecting the life of flower arrangement due to excessive water loss. For juicy cuttlefish, such as poinsettia, it is not advisable to insert it into water immediately after cutting. Instead, they should be cut off and burned on the flame of a candle or alcohol lamp, then some burned parts should be cut off, disinfected and washed with clean water, and finally inserted into water to prevent them from wilting due to excessive juice loss.

Method of placing roses: temperature

After inserting the water bottle into the cut flower, don't put it in direct sunlight or near the heating source, otherwise the flower will wither early. In addition, cut flowers should not be placed near ripe fruits, otherwise the petals will fall off quickly. For example, Chinese rose, carnation, narcissus, freesia, lily and gypsophila are all sensitive to the gas released by fruits.

Flower arrangement method of roses: blanching method

Soak the base of the flower branch in boiling water for ten seconds and then pick it up (fragile and delicate flowers can only be soaked for one or two seconds), which can block the incision and prevent the tissue fluid of the flower branch from overflowing, and has a good effect on herbal flowers.

The flower arrangement method of roses: burning method

When cutting flowers, rub a little alcohol on the incision and burn it in the flame. Don't insert the vase until the incision is close to black, which can keep it for a long time. But this method is only suitable for woody plants or plants with thick branches, such as radix aucklandiae, clove, plum blossom, peony, ivory red, chrysanthemum and so on.

Rose flower arrangement method: liquid immersion method

Before inserting the cut flower branches into the vase, soak the ends in the used waste developer for half an hour, which can prolong the flowering period of the flower branches.

;