After the computer is turned on, it cannot enter the system, and the following prompt appears: TRAP 00000000 1.

The hard drive is not far from death! !

Hard disk failure

Mainly due to hard disk aging or improper use of bad tracks and sectors. This makes it easy for the machine to crash during operation. Special tools and software can be used for troubleshooting. If the damage is serious, only the hard disk can be replaced. In addition, for motherboards that do not support UDMA 66/ 100, we should pay attention to the setting of hard disk operation mode in CMOS.

Inappropriate exercise

When the computer is moving, it often makes the internal devices of the machine loose, resulting in poor contact and computer crash. Therefore, violent vibration should be avoided when moving the computer.

Dust killer

Too much dust in the machine can also lead to collapse. If the floppy disk drive head or the laser head of the CD-ROM drive is contaminated with too much dust, it will lead to reading and writing errors, which will seriously cause the computer to crash.

Device mismatch

If the main frequency of the motherboard does not match the main frequency of the CPU, the external frequency will be set too high when the old motherboard overclocks, which may not guarantee the stability of operation and lead to frequent crashes.

Software and hardware are incompatible.

Three-dimensional software and some special software may not be started or even installed normally on some microcomputers, and there may be compatibility problems between software and hardware.

Memory failure

It is mainly caused by loose memory chips, virtual welding or quality problems of memory chips themselves. The contact fault of memory stick should be eliminated according to the specific situation. If there is a problem with the quality of the memory, the memory needs to be replaced to solve the problem.