Iphone6s, why hasn't the message been sent yet, but the other party has received the message?

Apple 6plus has such a situation (excluding human factors), it should be in the setting place, and the landlord has not opened it (iMessage), so it cannot be displayed and sent. Please follow my steps to set it up.

Details are as follows:

1, I just bought an iPhone6 phone, but I can't send a simple message. I think this is a very serious technical failure, but it is actually a very simple setup problem.

2. Edit a short message and send it out, but the message behind it shows that it was not sent.

3. Users can see that a red exclamation mark will appear on the icon after I edit the short message.

4. So I restarted my mobile phone. After shutdown and restart, I will try again.

5. After that, there is still the question of whether there is an ending. After editing the short message for many times, it still can't be sent, and none of the displayed messages have been sent.

Then it is necessary to consider that there is something wrong with the setting of the information center.

6. Open the telephone dialing interface, first check the number of your current SMS center.

The query method is to enter the combination of characters and numbers as shown below. Click the dial button.

7. After that, the system will automatically display the number of your current SMS center.

8. Then the user enters (*5005*7672* just found number #) in the dial interface again, and then clicks the dial key to reset the number of the SMS center. Then you try texting again, and it's back to normal.

Solutions to common problems of mobile phones

Details are as follows:

Phenomenon 1: The mobile phone is not turned on (the mobile phone battery is detachable).

Solution:

When a new mobile phone (or after upgrading or restoring the factory settings) is turned on for the first time, the mobile phone needs to be initialized, which may be mistaken for not turning on for a long time. If the battery is not turned on because of excessive discharge, take out the battery and connect the mobile phone to the charger to see if it can be turned on. If you can boot, charge the battery for more than 30 minutes, and you can boot normally.

Phenomenon 2: The mobile phone is put in the pocket and the touch screen is in contact with the body. You can't touch the touch screen to answer the phone at this time.

Solution:

Keep your hands and touch screen clean and dry, and press the power button (screen lock button) twice to recalibrate the touch screen itself.

Phenomenon 3: When there is oil or water on the hand or touch screen, the touch screen will fail.

Solution:

Dry the phone surface with a dry cloth, and press the power button (screen lock button) twice to recalibrate the touch screen itself.

Phenomenon 4: When a charger (especially a car charger and a non-standard Huawei charger) is plugged in, the touch screen of the mobile phone fails, and the noise signal of the charger has the same frequency as that of the capacitive touch screen, resulting in TP failure.

Solution:

1) Unplug the charger;

2) Press the power button twice;

3) Unplug the charger, take out the battery and use Huawei standard charger.

Phenomenon 5: some unstable software is installed on the mobile phone, which leads to the restart or automatic shutdown of the mobile phone; When the mobile phone shakes, the battery is loose (the mobile phone battery is detachable), which may also lead to the automatic shutdown or restart of the mobile phone.

Solution:

Smartphones, like computers, have a complex operating system. Some third-party software installed on the phone may cause the phone to restart or crash, restore factory settings or uninstall software incompatible with the phone.