How to adjust the model engine of aircraft model?

First of all, the correct running-in of the engine is the key to normal use and influence the life of the engine.

Oil: Use no less than 20% castor oil fuel or no less than 15% synthetic lubricating oil fuel. In general, it is forbidden to use methane fuel during running-in (unless you don't have ordinary oil). Please run in under the condition of rich oil.

Paddle running: Paddle running should be one size larger than the commonly used paddles.

Fix the engine: Please fix the engine correctly on a relatively safe test bench or plane (please fix the fuselage at this time). Try to find a friend to help. It is forbidden to stand on the rotating line of propeller. After confirming that the propeller is tightened, please stand in front of or behind the propeller to operate the engine. When the engine is started, please stand behind the engine and make adjustments.

Adjustment of oil needle: the new engine is in the adjustment parameters of standard gasifier when it leaves the factory. At this time, in order to prepare to use different standard oil, please open the main oil needle ring and idle oil needle for half a turn to prepare for the running-in of the new machine.

Trial operation: Please connect the battery with the voltage not exceeding 1.5v to the electric plug, and run it with the gasifier on for 20 minutes 10- 15 minutes, fully open for 5 minutes, extend the grinding time appropriately with the piston ring, and run it with a flying paddle for 5-65438 minutes after the initial grinding. Please use a starter or starting stick to help start the engine. Never start the engine directly by hand! (especially APC saber pulp)

Friendly reminder: the model engine is not an ordinary toy. Please pay attention to the safety of yourself and others. Children should be done with the help of their parents. Please pay attention to hand safety when using APC saber paddle! When oil enters your eyes, please wash it with clear water immediately and seek medical treatment in an emergency!

Please refer to /article-65.html for complete debugging steps.