How to make a miniature Christmas wreath in the mini world How to make a miniature Christmas wreath

The materials needed for miniature Christmas garlands in mini-world games are model workbench, green hard sand block, yellow hard sand block, red hard sand block and orange hard sand block. After putting the model workbench on the ground, we first take out the green hard sand and make the main body of the wreath. Make a circle with a diameter of 1 1.

Method for make miniature Christmas garlands:

The required materials are: model workbench, green hard sand block, yellow hard sand block, red hard sand block and orange hard sand block.

In the first step, after we put the model workbench on the ground, we first take out the green hard sand block and make the main body of the wreath. Make a circle with a diameter of 1 1.

Then, we thicken the garland by 2 squares and add 2 circles in the inner ring.

Step two, we take out red hard sand blocks and orange hard sand blocks. Decorate the wreath with some flowers! Don't decorate the red box in the picture, because we will make a red bow there!

Let's take out the red hard sand first, and then make a 5x3 cuboid.

Then draw an irregular figure on the four corners of the rectangle. (See the picture for details. The buttons in the picture do not belong to the garland itself, so they stand out. )

Then repeat and make this irregular pattern on the other three corners.

Then take out the orange hard sand and make an orange cross in the middle of the bow.

Step three, we take out yellow hard sand to make Christmas bells. Make a 3x3 yellow rectangle under the orange cross.

And then extend to both sides.

Now make the front and back of the bell, circle it and fill it. Please note that this circle should be reduced.

Then there is the back of the clock, just like the front of the clock.

It takes only 3 steps to make a Christmas wreath!

In the fourth step, we can also take out a customized model maker and enlarge the Christmas wreath a little.

Open the backpack and select the custom modeler.

After putting the customized model on the ground, we choose the customized model.

Click "New", and then select the Christmas wreath we just made.

Then click the enlarge icon, and then enlarge the garland to the maximum! And click the Finish icon. (Please see the picture for details)

After clicking the finish icon, we should select the box after entering a name and description.

Here's how it works! A very beautiful Christmas wreath was made perfectly in this way!