How to put the bookshelf speakers, how to put them.

When it comes to the placement of bookcase speakers, you may pay attention to it. If these two things happen to exist in the same space in your home, how to put them properly? If you encounter similar problems, you may be confused. Many people will ask how to put the bookshelf speakers after they are bought. Different placement positions have different effects on bookcase speakers. Accurate placement can better reflect an acoustic effect. What are the placement methods of bookshelf speakers? Let's get to know each other.

At present, bookcase speakers are placed in various ways. There are seven kinds of typical bedroom space layout commonly used: regular triangle method, 33 1 ratio method, wall layout method, inner shaft method, 337 ratio method, diamond layout method, and long side back wall layout method of sound box.

Regular triangle method

The regular triangle method is also called near-field listening method. The first condition is that the bookshelf speaker should leave the back wall and side wall. The second condition is to draw two bookshelf speakers and listening positions into a regular triangle. The third condition is that the inward projection angles of the two speakers should also be above 45. The fourth condition is that the regular triangle can be large or small.

The square is smaller when the room is small and the rear strength is not great; The regular triangle is bigger when the room is big and the back force is big. The advantage of this method is that it can reduce the excessive interference of the surrounding wall light on the speaker direct sound, thus obtaining a good sense of positioning and a wide and deep sound field. This is the most direct and exact arrangement that needs to be heard.

33 1 proportional method

Divide the length of the room into three equal parts and the width into three equal parts. Put the bookcase speaker at the intersection of the first equal part of the length and width. The speaker may have a slight inward convex angle, or even no inward convex angle, and the listening position cannot be attached to the back wall. This method is limited to the space with large size and even proportion distribution.

Stick to the wall

Put the bookcase speakers near the back wall, and it doesn't matter if they are 50kg, 30kg or 20kg away from the back wall. Just adjust them yourself. Generally speaking, speakers do not have to project angles inward. When the high frequency is sharp and the middle frequency and low frequency are weak, the middle frequency and low frequency can be smooth and the whole high, middle frequency and low frequency can be balanced. But it will also make sound stage shallower in depth and narrower in width. However, at the expense of the performance of sound stage, it is an accurate method to balance the harsh and ugly sound and seek a good sound.

Internal axis method

If the listening environment is complex, the sound absorption may be uneven, the room may be too long and too thin, the sound is sharp, the midrange is thin and the bass is not enough, the following "in-axis method" will be better. First, put the bookcase speaker between 1/3 and 1/2 in the room, and then put the speaker as close as possible to the side wall. If the room is too wide, there is no need to be near the side wall. The recovery angle of speakers should be much greater than 45 degrees, and the listening position should be between 0.5m and 1m after the projection angles of two speakers intersect.

3 17 ratio method

Methods: The length of the room was divided into three equal parts, the bookcase speakers were placed in one third of the length, and the distance between the two speakers was 0.7 times that of two thirds of the room length. It is better for the bookcase speakers to have a slightly inward protruding angle, or not, and the listening position should not be attached to the back wall. Effect: As a space with a fairly large size and even proportion distribution, this method can obtain balanced sound and a wide and deep sound field.

Diamond pendulum

This method is only used in square spaces. Think of the square space as the place where the two sides of the diamond are against the wall. The diamond-shaped sharp corner behind the bookshelf speaker and the diamond-shaped corner behind the listening position should be treated with cylindrical sound wave propagation, and the second speaker should not be too close to the side wall. This method is specially used to solve the problem that the standing wave of the bass boom in square space is too strong. If the square space doesn't want this, the fortress will have a lot of furniture to "dry" the standing wave.

The back wall of the long side of the speaker swings

If the volume sense of low frequency is not enough in the bookshelf speaker system, then the long side rear wall pendulum of the speaker can be used. However, it should be noted that this kind of swing has its own advantages and disadvantages for sound. Although the sense of quantity in the middle and low frequencies is strengthened, the range and depth of sound will become worse. Therefore, if we want to strike a balance between them, we must try to enter gradually. In a rectangular room, the general experience will use the short side as the back wall of the bookshelf speaker. However, this placement is reversed, and the long side is the back wall of the bookshelf speaker.

Conclusion: If you have similar doubts, you should understand a lot after reading this article. If you follow the placement method suggested in the article, the final effect will not be bad. The placement of all kinds of furniture at home must also be skillful. If the furniture is arranged according to aesthetic principles, the overall effect of the home will be very different from before. This is how I put the bookcase speakers for you. I hope you will like them best.

Heart of the King 2 Click on the demo.