Analysis of matters needing attention in diamond drilling

Drilling with diamond is to use high pressure to make water pass through a very small gap. It can be used to easily drill holes in steel plates because of its extremely high passing speed and high kinetic energy. Moreover, drilling with diamond can also make water and soil mix into mud, so it has a protective effect on the wall. Next, let's learn about the precautions and skills of drilling with diamond.

First, the matters needing attention in drilling rhinestones

1. It should be noted that professionals must undergo special training before being hired for operation and storage.

2. It is very important to keep the rig clean and dry normally. During storage and storage, the motor should not be put into water. When not in use, it should be wiped clean and put in a dry room. If it is not used for a long time, the drill bit should be removed. The guide rail should be greased.

3. It should be noted that all equipment, facilities, safety devices, tool accessories and personal protective equipment on the construction site must be inspected regularly to ensure that they are in good condition and can be used safely.

4. Pay attention to the operator must wear Qualcomm insulated water shoes, safety helmet and insulating gloves at work.

5. It should be noted that the drilling rig must be fixed and reliable at work to prevent accidents. When working at height, certain safety measures must be taken. Before operation, check whether the frame is firmly fixed and whether a drill bit is installed.

6. It should be noted that during drilling operation, there must be enough water to prevent waterless operation.

7. The drill must be steady, and don't shake it from side to side, because when you shake it, it is equivalent to increasing the friction of the drill.

Second, diamond drilling skills

1, when punching holes, we first find a roll of transparent adhesive tape about 5cm, then stick two adhesive tapes about 20cm below the position to be punched, and then stick an airtight and sturdy convenience bag under the hole, so that it is not too small or too big, 20cm-30cm is enough, and then draw a circle around the hole to be punched with adhesive tape. First, we punch a hole with a diamond, then fill the diamond with water and put a rag of the right size. Generally, the wall of 25 can be penetrated at a time, which takes about 5 minutes. The wall of 37 is more troublesome, but it needs to be refilled halfway, but it can be penetrated in 10 minutes, and the soil mixing time is a little longer. Just tear off the convenient bag after punching in.

2. The most time-consuming thing is drilling holes. When you encounter difficult holes, it is common to be tortured for an hour. Therefore, it is not recommended that you use friends with rhinestones to grind, which will do great harm to the drill or the drill itself. But now I use the convenient bag according to the cabinet machine. It takes a few minutes to stick a bag, which not only saves you a lot of time, but also tears the bag directly after drilling without cleaning anything.

These are the precautions and skills for drilling rhinestones that we introduced to you. Drilling rhinestones requires extremely professional skills. Therefore, before operating the diamond, some professional training is needed. If you operate without professional knowledge, it may be dangerous.