Safety construction technical disclosure system?

What is the specific content of the safety construction technical disclosure system? The following Zhong Da Consultation will answer your questions.

A, the preparation of safety technical measures plan, should be based on state-owned labor protection laws and regulations and various safety technical standards, according to the company's annual construction and production tasks, the characteristics of various projects to determine safety technical measures, in view of the hidden dangers found in safety production inspection and new technologies, new equipment should be taken to continuously improve working conditions and prevent the occurrence of industrial accidents. Second, the scope of the safety technical measures plan: 1, various protective devices and safety devices (such as safety tags, safety hooks, safety doors, overspeed limiters, overwinding brakes, door electric locks, safety handles, safety brakes, etc.). ) installed on lifting machinery. 2, all kinds of mechanical safety start and quick stop equipment. 3. refit machines and equipment for safety. 4, electrical equipment installation contact leakage prevention facilities (including standard distribution box). 5. For the sake of safety, install low-voltage lighting equipment. 6. Under the condition that the original equipment is simple and the whole operation process cannot be institutionalized, auxiliary mechanized equipment is used to carry out single arduous or dangerous lifting and handling work. 7 signs, signals and protective equipment installed in dangerous places in the production area. 8. Install protective devices for training in holes, pits, ditches, elevators and funnels where workers may reach. 9. In the production area, where workers often pass, safe and fixed passages and temporary bridges. 10, dust collection equipment and dust prevention facilities for eliminating dust and various harmful substances. 1 1. Facilities to reduce or eliminate noise and vibration during work. 12, mechanical, electrical equipment and other transmission parts protection device. 13. Ventilation devices installed to keep the air clean or make the temperature and humidity conform to labor protection and safety. 14. Lounge, dining room and food heating equipment in the workplace. 15. Buy or write reference books, publications, posters and slogans on safety technology and labor protection. 16. Measures to establish and implement rules and regulations related to production safety. 17, tools and instruments needed for safety technology and labor protection. 18 women's clinic and its equipment. Three. Safety technical measures shall be formulated by the company's security department according to the actual situation of the project and the company when the project starts, and shall be implemented by relevant departments after being approved by the company manager. IV. Safety technical measures for major projects shall be organized and implemented by the company, while general projects shall be implemented by grass-roots departments, and the security department shall be responsible for regularly checking the implementation. Five, safety technical measures and the cost of using materials, should be effectively guaranteed. The specific planning measures are as follows: 1. Set up red lights and warning signs on scaffolding on both sides at night. 2, the establishment of safety responsibility system, the responsibility to the people, do a good job of safety ledger, and strive to implement the "ten measures" and "six disciplines" of safety production. 3. After the construction personnel enter the site, they must go through three-level safety education, hold a mobilization meeting for safe construction and civilized construction at the scene, and learn safety specifications and safety operation procedures as well as basic knowledge and requirements related to safety. 4, important parts and aerial work should take special safety precautions to prevent accidents. 5. Construction personnel should wear safety helmets when entering the site, fasten safety belts when working high above the ground, set up temporary power lines overhead, and hang safety signs in the distribution box. 6. Construction personnel shall set up "one map and five cards" when entering the site, and be equipped with full-time security officers. 7. All mechanical and electrical equipment shall be managed and operated by special personnel, and the power equipment shall be protected by grounding. The distribution box shall be equipped with an electric shock protector, and the main switch of the distribution box shall be located at the edge of the message room. 8, do a good job of fire safety. Focus on the kitchen and carpenter's shed, so that the carpenter's shed can be cleaned once a day. Smoking and open fire are not allowed in the wooden shed, and the kitchen should be watered in time to put out the fire, especially at night. 9, the site materials piled up in an orderly manner, template removal should be arranged in time, and the team should do a good job in the left hand. 10, do a good job in "four ports" and "five sides" protection facilities, immediately rectify potential safety hazards, nip safety accidents in the bud and put an end to safety accidents. 1 1. According to the surrounding conditions of the project, the safety shall be hoisted in time, and protective railings shall be provided. After the erection of all kinds of scaffolding is completed, it can only be delivered after it is inspected and accepted by safety technicians. No adventure. 12. Workers' living quarters are arranged separately from construction areas. 13, the wall of the construction site is brick, 2.5m high. There are doorposts on both sides of the gate, and guards are on duty day and night. No other personnel are allowed to enter the construction site. 14. The roads, dormitories and office floors in the construction site are all concrete. 16, adhere to civilized construction, clean up construction waste at any time, ensure smooth roads on the site, and timely organize the discharge and transportation of construction wastewater and sludge on site. 17, do a good job in civilized management of the construction site, solve the problem of "dirty, messy and poor", keep the site clean and tidy, and create a good construction environment.

For more information about project/service/procurement bidding, and to improve the winning rate, please click on the bottom of official website Customer Service for free consultation:/#/? source=bdzd