How to manually sort trash cans?

It is not difficult to make a sorting trash can by hand. The specific steps are as follows:

Material requirements: cardboard or thick paper.

Scissors, rulers, pencils

Glue or tape

Graffiti pen or other brush (optional)

Steps:

1. Prepare two pieces of cardboard with the same size. Carve four lines of equal length with a steel ruler and pencil, and mark the dotted lines at the three corners needed to build the shell.

2. Roughly cut the cardboard or paper along the dotted line on the drawing, leaving the edge of the bonded article.

3. Use the first side as a template to make a two-layer cloth and its edge part. Insert the large cylinder into the wall edge device, paste the inner and outer edges respectively, and then adjust (note that the large cloth needs to be about 5cm/2inch longer than the lines that make up the section).

4. Pay attention to the details of the top and bottom, and try to put a heavy item in after pasting.

5. If necessary, beautify the trash can with graffiti pens or other painting tools to make it more attractive. Sorting trash cans can be painted with different colors or logos to show classification.

6. Finally, add plastic bags or other suitable garbage bags at the bottom or top to clean up the internal garbage.

Such a simple and easy hand-made sorting trash can is completed. Of course, this is just a simple scheme. You can also design more personalized classified trash cans according to your own needs and creativity.