Who can tell me how to install a simple telescopic hanger?

1. Install the top seat: after the position is determined, drill holes with an electric drill. After drilling, fix the four top seats with expansion screws (if the rod is longer than the normal size, the length should be adjusted accordingly).

2. Installation corner: the corner can be installed on the roof or wall of the balcony, and the corner is 50-70 cm away from the movable top seat. A triangle (45-degree angle) must be formed in the middle of the movable top seat, keeping the same vertical line with the position where the hand is installed.

3. Steel wire connection: a set of clothes hangers contains two steel wires. First, take out a steel wire. First, one end of the steel wire passes through the bearing steel wire groove of the corner, then through the bearing steel wire groove of the movable end top seat, and then through the bearing steel wire groove of the fixed end top seat, so that the steel wire is vertical to the ground. Then, insert the top cover from the steel wire and block the top cover. So is the other end of the wire. The installation method of the other steel wire is the same as the first one.

4. Dry connection: thread a hanging ball at the end of each steel wire and tie a knot in the hanging ball; Then pull the suspension ball until it abuts the top seat. At this time, the steel wire is pulled out from the corner position to form a double-stranded steel wire, which is clamped on one side of the handle. Loosen the steel wire in the crank handle, put down the hanging ball, pass the drying rod through the hanging ball, and then tighten and fix the screw at the hole position of the hanging ball; Finally, plugs are installed at both ends of the drying rod.