Joke Collection Website - Mood Talk - Correct installation method of door lock What are the precautions for door lock installation?

Correct installation method of door lock What are the precautions for door lock installation?

In the process of decoration, the installation of the door lock is a relatively private part. Good door locks are not only very safe, but also very practical. It can basically be used for decades without replacement. In fact, a good door lock is not enough, and the master's locking method is also an aspect to prolong the service life of the door lock. Today, Bian Xiao will talk to you about the correct installation method of the door lock and the problems existing in the installation of the door lock.

1. Check the installation of lock body and hook.

First try to open the door with the key, check whether it is smooth, check whether the hook between heaven and earth is aging and whether the door panel can be deformed. After all inspections are completed, remove the panel lock body. Take out the new lock and make a simple comparison to see if the door panel needs to be reamed, which should be done before putting it into the lock body. Then, put the smart lock body into the door and compare it with the old lock body. If they are not consistent, they need to be modified by hole modification drawing. If they are consistent, put them directly into the lock body and fix them.

2. Use accessories to help with installation

Doors without doorframes need accessories to assist in installation. Place the U-shaped groove, rubber gasket and stainless steel gasket (on one side of the locking screw) on the door, lock the door with headless hexagon socket head screw, and then fix the iron plate on the U-shaped groove. Different types of electromagnetic locks are used for doors with different thicknesses.

Step 3 troubleshoot

Finally, enter the debugging stage. First try to see if the handle is locked, locked and bounced off, and whether the door safety and cat's eye are smooth. If the handle does not rebound, the fixing screw can be adjusted.

1, modify the original password

After all debugging, the smart door lock will be set. In order to ensure the safety of family members, we must change the original password and enter the fingerprint information of the administrator. Any operation requires a password or fingerprint to determine its administrative rights.

2, measuring hole spacing

When opening a hole in the door frame, measure the distance between the hole and the edge of the door frame according to the thickness of the door. If the measurement is not accurate, the lock tongue will pop out because of the wrong position, resulting in the situation that the door cannot be locked, or because the gap between the door and the door is too large, it cannot be closed tightly after locking the door, resulting in a slight swing back and forth.

3, calibration should be careful

The whole process from door lock disassembly to installation and debugging takes more than 2 hours. If the original keyhole is small, it will take a lot of time to cut it. Calibration is a patient job, and any mistake may cause losses.

The above is the correct installation method of the door lock shared by Bian Xiao. What is the relevant information about the precautions for door lock installation? I hope it helps you.