How to change the wiper in changan CS55? I'll tell you the steps.

Wipers are used to brush away raindrops and dust attached to the windshield of vehicles, so as to improve the visibility of drivers and increase driving safety. The rear windows of hatchbacks and recreational vehicles are also equipped with wipers.

The replacement steps of the wiper in changan cs55 are as follows: 1. Remove the wiper from the original factory and press the square clip on it! Press your finger in. ?

Two: press the middle square to pull it out, as shown below, and it will be easy to pull it out.

Three: Take it off and that's it. Take the old one down and put the new one on.

Four: Some models have different wiper sizes between the driver's seat and the co-pilot. Generally, the driver's seat is long and the co-pilot's seat is short. Don't put it backwards. It doesn't matter if they are the same size.

Five: Install the wiper of the passenger seat and look at the direction. Finally, look at the installation effect, see if there is any reverse installation, and the inclined plane faces forward.