Nail diamonds always like tips on how not to stick when they fall.

In life, nail shops are generally more expensive, but getting nails at home will save money and be more beautiful. If you can't stick to sequined diamonds, you can read the tips provided in this article.

What should I do if my nails and diamonds always fall off (1)? The phototherapy glue is not dry because the bottom of the diamond is opaque. If you apply too much glue, the glue under it will fall off if it doesn't dry.

(2) No edging. After the seal coat is finished on the nail surface, dip it in the glue with a small pen or wrap the seal coat around the diamond jewelry, which will be much more stable.

Tips on how nail diamonds can't stick (1) Use a drill pen or tweezers to get diamonds, not directly by hand.

(2) Apply glue or glue to the nail surface with a dispensing pen, and pay attention to the dosage. Too much glue will form offset printing, which is ugly!

(3) Stick the drill bit on the glue with a pen. If glue is used, press the drill bit with an orange stick until the glue dries.

(4) Then, wrap the diamond ornaments with a washable sealing layer, which will be stronger.

(5) For small diamond ornaments, it is recommended to stick the drill first and then seal the layer; For large diamond ornaments, it is suggested to seal the layer first, then stick the drill, and then edge it.

(6) If the surface of the diamond jewelry is accidentally stained with glue, it can be removed with a glue remover; If you get glue, you can wipe it off with alcohol before the light comes on, and you need to cut it off with waste dead skin scissors after the light comes on.

The reason why nail seal 1 is not durable, the choice of lamp and the control of time.

It usually takes a long time to irradiate the sealing layer-3-5 minutes for ——UV lamp, 90 seconds for LED lamp and 30-60 seconds for crescent lamp. Whether it is LED lamp or UV lamp, different brands have different power. It is suggested that every manicure colleague try the lamps and products you use in their own hands first, and then wait for how long before painting them for customers. In addition, we should pay attention to check whether the lamp tube is aging and replace it in time.

2. Wipe off the floating glue immediately after lighting the lamp.

Scrub the sealing layer and turn on the light. There is floating glue and sticky on the surface. Do not touch or wipe with your hands immediately after irradiation. Wait for about 30 seconds, and then wipe off the floating glue with a special cleaning cotton to avoid the nail surface from expanding with heat and contracting with cold. It is best not to choose a cotton piece that will fluff, so as not to lose hair and destroy the bright layer on the nail surface.

3. The seal coat is too thick.

If the seal coat is painted too thick, the color will be yellow and dull.

4. Causes of hand cream

Just finished manicure "temporarily not bright"? Because I didn't apply hand cream until I finished. Too much hand cream will dull the nail surface. Just scrub with alcohol.

5, the choice of seal coat

Wash-free drying, no need to clean after drying, the luster is not lasting; Brushing the seal coat requires brushing, and its luster will slowly shine out. Non-washable sealing layer is used to make style template and attached drill style; If you are a guest, you will generally choose to brush the seal.

6. Others

Some guests were exposed to chemicals after manicure, which affected the brightness of the seal; If you use a matte seal, it will not shine itself.