Which department to find to measure the housing area, and how to measure the housing by one person?

Measuring the housing area is carried out by a special person. You can find a decoration company or the Surveying and Mapping Brigade of the Housing Authority, but there is a charge for this service. If you don't want to find a decoration company, but choose to install it yourself, I suggest you do a good job when measuring the house!

Which department should I look for to measure the housing area? 1, find the Surveying and Mapping Brigade of the Housing Authority to measure, and their statistical data will be more accurate, which is not much different from the area above the real estate license. ?

2, you can also find a decoration company to measure, measure the area of each room, and add up the measured area of each room to be the total area of the house.

How to measure a house by yourself? 1. Measure the preparation before the house.

1. Pen: It is best to prepare two or three pens with different colors.

2. Ruler: 5m tape measure and electronic ruler (measuring instrument).

3. Paper: special room book or A4 white paper (drawing floor plan).

4. Mobile phone: Take pictures of the structure of the house in case the frame is unclear.

5. You can search the floor plan online and draw it with CAD to avoid direct hand drawing.

Second: hand-drawn floor plan

Let's take a general look at the building structure, whether there are insulation walls, beams and so on. , and suggested starting from the door. Generally, you can draw a single line or a double line on the plan, depending on your personal situation.

Three: measurement

1. Start from the porch, write the measured data to the position corresponding to the drawing, measure the length, width, height and settlement of the room with a tape measure or measuring instrument, then measure the height, width and ground distance of the window, then measure the height and width of the door, then measure the beam height and Liang Kuan of the cross beam, and finally measure the height of the strong and weak ionization ground, the distance from the side wall and the position of the water pipe.

After measuring, check it carefully in case you miss anything.

Never forget to measure the entrance door.

Take photos of beams, water pipes, electrical boxes, holes, floor drains, water supply and drainage, and complex shapes, so as to facilitate the later drawing of elevation and ceiling.

There are two ways to measure a ruler. The first method is to measure the surrounding walls in an area, and then measure the total length and width. The second method is to measure them clockwise. You should measure every dimension from the moment you enter the house or find a starting point. Don't take any chances unless you are sure you can let it out, and then measure the total length, width and height of each space.

Even if it is necessary to change the position of water drainage and water supply that is prone to water leakage later, it should be measured according to the distance from the center of the pipeline to the wall, the height of water supply, the height of floor slab, the height of beam, the maximum position of space, the height of windowsill, the height of window, the height of strong box, the height of weak box and the height of door.

Finally, be sure to take photos, space photos and local photos.