Nanbiji manicure mo Jing fen bu

1. Priming

Apply the primer evenly on the nail surface, make the primer and nail surface more docile several times, and then shine for 30s.

2. Colored glue

Apply a small amount of colored glue to the nail surface several times, and the light will be on for 30 seconds. If you want to make the color more saturated, you can apply color glue twice.

The more saturated the color, the more colorful the powder will be.

Step 3: coating the sealing layer.

Apply washable seal/toughened seal evenly on the nail surface and shine for 30s.

If the lamp shines for too long, it will not be sticky, resulting in no powder. If the lamp irradiation time is too short, there will be a heavy graininess.

Wipe magic mirror powder

Dip the sponge stick/silicone stick/finger in the magic mirror powder, and prepare to wipe the powder. When rubbing powder, don't eat too much powder at one time, but eat it in small amounts several times.

When rubbing powder, you should be a little strong.

Step 5 remove dust from the nail surface

Use a dust brush to sweep away the excess mirror powder, and observe whether the mirror powder is even and shiny. If it is uneven, rub it again until it is even and shiny.

Friction and polishing

The extra magic mirror powder on the edge and cross section of the fingertip should be gently wiped off with a sponge.

Magic mirror powder will tilt up when rubbing your fingertips.

7. Apply reinforcing glue

Choose a thick reinforcing glue and evenly spread it on the nail surface, and then light it for 60s after edging.

If the reinforcing glue is too thin, it is easy to dilute the mirror powder; The uncoated reinforced mirror powder is easy to fall off.

8. Coating

Apply the seal evenly to the nail surface, and remember to trim the edges.

9. Complete