How to install computer system through LAN

With the system CD and USB flash drive, where is it worthwhile for us to install the system with network cable? But if an enterprise or an Internet cafe wants you to install a system for one or two hundred computers, screen printing can come in handy. Let me teach you how to install a computer system through a local area network.

By installing a computer system through a local area network, a computer is randomly selected in the local area network and set as a screen engraving server.

Open Jackie Chan's full-automatic screen engraving tool, and click? Only screen-printed c disk? And then order? Browse? Select the gho system image file, and finally click? Start carving? . (note: choose? Only engrave disks c, d, e and f? You should ensure that the client is partitioned, otherwise an error will occur. If you choose? Full-screen carving? , then there is no need to partition, no matter whether the client hard disk is partitioned or not, it will automatically become an area)

If you follow the existing network topology, the server will have been set up. The remaining work is to set the client to boot from the network and automatically install the system. The engraving tool comes with a DHCP server, and the client can automatically obtain the IP address from the local area network for communication.

But nothing will go as expected? Perfect? . Let's start with the common network topology in our family. The four LAN interfaces of the wireless router actually play the role of switches, which can be regarded as switches. However, in this environment, it is often impossible to install it normally, because the wireless router also has its own DHCP service, which conflicts with the DHCP service of the lettering server, resulting in the communication between the client and the server. Therefore, it is necessary to set the DHCP service of the screen engraving tool.

Set the IP address allocated by the DHCP service of the engraving tool to be in the same subnet as the IP address of the server. The IP of the server is192.168.1.198, so set192.168.1.20/kloc-0. Remember? Save? .

After the server is set up, it will be in a state of waiting for connection, waiting for the client to connect.

Next, let's start the client and set the PXE network boot in the BIOS. There are many BIOS versions with different settings. Whether it can be set depends on your technology and whether the motherboard supports PXE startup. If it is a motherboard before 10, it may not be supported.

If it goes well, it will enter the state shown in the figure. It is also waiting, waiting for the server to click? Send? .