Changan CS55 upgraded diy and installed the rear air outlet. Let's talk about our feelings!

When I was wandering around a fish, I happened to meet someone who sold the rear air outlet panel and air duct of the car. I always wanted to dress, so I started directly.

Sun Xian got off the bus and honked his horn to say hello when meeting his friends in Nanchang! ? Next, open the

Pry the panel hard with a crowbar, break it, and then take it off. It's simple. There are four plugs. Relax.

Next is the front panel, no plug.

Then grab the lighter with both hands, hmm ~ work miracles, again, there are three plugs, relax.

Next is the backboard. I forgot to take this photo. Fill in a picture. Pry the seam along here, then grab the panel and pull it out. There is a usb plug in it. Pay attention.

When disassembling the armrest box, pay attention to the fact that there are four screws at the bottom inside.

There are two screws in front of the armrest box? In addition, it must be noted that after removing the rear panel, you must continue to remove the cover and all the screws at the bottom of the armrest box before pulling out the armrest box, otherwise the buckle will break, and I will break two buckles! ! I forgot to take pictures. If you are careful, you can find it. The rear seven screws and the bottom four screws must be removed. ? After removing the screws, you can pull out the armrest box.

This is what the armrest box looks like after it is removed. ? Thank you @ qin521110 @ My Charming Pig? I forgot to take photos of two posts, but you can check @ My Pig's post, which contains detailed screw positions and methods. Thanks again. ? Because there is no reserved interface for the rear air duct in the dark, and the distance between the air duct joint and the main pipe wall is several centimeters, we must find a way to connect it ourselves. So I took local materials and cut the water pipe of the old engine room water tank into two sections. Two 32 holes were opened, and the process will not be described in detail. See the figure below for the finished product.

After the installation, we began to put it back.

The effect after completion is as follows

Remove the old panel

That's all. Let me tell you how I feel. During the installation process, I met a blue 55 rider and was ridiculed. It's unnecessary to say that I pretend to be B. What I want to say is that I just think it is a very difficult experience to disassemble and modify a car. I like this feeling and process, and I have a sense of accomplishment! I believe there are many riders who think the same as me! ! ? By the way, the installed pipe is actually the same as the downdraft, and the air conditioner should be adjusted to the position of blowing feet, so there will be wind at the back outlet, and the wind is general, not too big. If you have high expectations, don't do it if you deserve to get on the bus! ? Well, thank you for listening to me! We will continue to change seats next week. We have just reserved a pair of seats with electric ventilation and heating. We will put them on next week and see how they work! !