What should I pay attention to when braking with vehicle identification system?

Anbeichi summed up the following points, hoping to help you.

1. In general, users are not allowed to change the wires laid in the box before leaving the factory, and only need to connect the 220V power supply to work.

2. The power supply of this machine must be equipped with ≥ 15A leakage circuit breaker.

3. When the product leaves the factory, the length of the retaining bar and the hairspring has been adjusted to the best condition, and the length and weight of the retaining bar shall not be increased or decreased at will. In order to avoid losing balance and danger. If you need to change it, you must ask a professional to operate it.

4. When the road brake is working, it is forbidden to open the lid and door to avoid personal accidents.

5. It is forbidden to place items or someone standing or walking under the bar when lowering the bar.

6. Mechanical switch limit and photoelectric switch limit have been adjusted to the best state before leaving the factory, and shall not be transferred at will.

7. In case of power failure, turn off the power first, and then swing it manually by hand until the brake lever is in a vertical position.