Installation method and matters needing attention of lamps and lanterns

The installation method of lamps and lanterns is as follows:

Installation method of ceiling lamp: first put the chassis on the roof, draw the punching position according to the fixed position, and use an impact drill to punch a hole in the position to be installed. Use a hammer to fill the fixing parts (such as expansion screws) into the holes. It should be noted that the bearing capacity of the fixing parts matches the weight of the ceiling lamp to ensure that the ceiling lamp is fixed firmly. Pull the wire from the roof out of the hole in the chassis, and fix the chassis in the above position with screws. After fixing, connect the conductor with the conductor of the chassis, wrap the adjacent and exposed conductor with insulating tape, and finally install lamps and lampshades.

Installation method of chandelier: When the chandelier is fixed, it is also necessary to draw drilling points, punch holes with an impact drill, and then drive expansion screws into the holes. It is worth noting that because the load of the chandelier is generally greater than that of the ceiling lamp, it is necessary to fix the ceiling with a metal hanging plate or hook first, and then adjoin the base of the chandelier, which can make the installation of the chandelier more stable. Tighten the screws and the base will be installed. The exposed parts of Lian Bi power cord and copper wire are wrapped with insulating tape. Then connect the boom with the base and adjust the appropriate height. Finally, install the lampshade and lamp container of the chandelier.

Precautions for installation of lamps:

Pay attention to the size of the safe drilling hole: for the safety of family members, fix the lamps. If there is no special requirement, the hole in the wall is generally 6 mm When installing and using the impact drill, you must install a matching drill. Pay attention to the drilling depth when drilling to ensure that the expansion screw can completely enter.

Pay attention to the safety of the power supply line: the wire ends adjacent to the ceiling lamp power supply line should have good electrical contact, and it is best to wrap them with vinyl cloth and connect them at a certain distance. If possible, try not to put the thread end under the unified metal sheet to avoid the danger of short circuit.

If you need to find a professional lighting installation master, you can go to Luban to find you. The above are the installation methods and precautions of lamps. I hope it helps you.