How to repair auxiliary inclined shaft when driving excavator?

How can we repair the slope beautifully and meet the construction requirements? Let's talk about the simplest soil compaction slope. The excavator is on a slope 2 or 3 meters high. Suppose that the slope to be repaired is a vertical surface tens of meters long, and this surface can be divided into the top, slope and bottom of the slope. If the construction party does not require slope repair and puts lime lines, the master who can repair the slope will work really fast (this is the simplest, and it is almost the same whether to put lines or not). Pressing this slope is most suitable for beginners to practice. That is, the whole slope, at first glance, is straight from the top to the bottom of the slope, and it is also straight from beginning to end. This is the premise of ensuring the same slope, and it is a beautiful first step to repair it. Then, arrange the excavator with the chain parallel to the top of the slope. The advantage of this is that the position of the bucket does not need to be adjusted when pressing the slope. 200 excavators, 0.8 buckets, press the slope with a bucket width before pressing. Straightening is to use your eyes. It has been divided into mud before. Just look at it. Leveling means that the slope you press out is parallel to the gray line. You can press the bucket teeth on the gray line first, observe the distance between the teeth on both sides and the gray line, and then extend it. If you press it for a few meters, you can see whether the slope has changed and keep it straight. Generally speaking, you should focus on the bottom and slope. Look at the bottom of the slope. If you don't pay attention, the bottom of the slope will not be straight. In fact, let's talk about repairing soil slopes. The difference is that the slope with solid soil is difficult to rework, and a mistake can be seen at a glance, especially the soil or stony wind fossils. If the slope is steep, it can't be made up. Moreover, excavators that fix soil slopes are mostly repaired from top to bottom. For beginners, the line of sight is not good and the slope is not easy to grasp. Personally, I suggest getting off the plane if you are not familiar with it, especially when repairing the slope with long teeth. Sometimes excavators are prone to make mistakes. There is no way to repair the front face, so we can only make a rough outline with the cooperation of rotation and boom, and then make a fine repair with the back of the bucket. It is the best way to repair the slope. The main thing is to make it straight and the slope should be consistent. If the slope is not required, it will be pleasing to the eye. When using rotary and boom to dig mud, leave as little mud as possible to avoid rework. All the above are very basic common sense of slope repair. Further, it is difficult to express it in words. Besides, a master who repairs slopes can never repair slopes well and quickly. This process needs to constantly sum up experience, communicate with people and learn, but also use it flexibly and improvise ... Generally speaking, slope repair is a test of care and patience, eyesight and self-control for beginners.