Joke Collection Website - Talk about mood - How about Laiyang test subject 2? Let's talk about what we passed.

How about Laiyang test subject 2? Let's talk about what we passed.

The test sequence of subject 2: starting uphill, parking at a fixed point, parking sideways, driving in a curve, turning at a right angle, and reversing into the warehouse. Analysis: Be careful, these places are easy to deduct points: failing to fasten the seat belt buckle 100, failing to fasten the door buckle 100, starting without turning the turn signal, changing lanes, overtaking, failing to turn the turn signal or turning the turn signal for less than 3 seconds before parking, deducting 10 (failing to turn the turn signal) ), flameout once: 10. 1. Right-angle turning station: the road length is 1.5 times the vehicle length, and the road width is the wheelbase of small vehicles plus 1 m. Scoring standard: Any wheel that hits the edge line of the road or stops halfway is unqualified. Tip: It's almost not difficult to turn at right angles. During the examination, students should learn to observe the marking line (protruding point) on the left side of right-angle turn with rearview mirror. When the left ear window of the vehicle passes this mark, you need to start turning the steering wheel to pass easily. Second, after the implementation of the new curve driving regulations, the arc radius of the curve driving field of C 1 driver's license is 7.5 meters. Vehicles need to enter from one end of the S-shaped lane and leave from the other end without pressing the line. Scoring standard: Any wheel that hits the edge line of the road or stops halfway is unqualified. Tips: Look farther, slow down and drive along the outer ring road as far as possible, that is, when the road is about to turn left, the right wheel is close to the edge line of the right road, so that the small rearview mirror on the inner cover of the car is always at the edge of the outer white line through the steering wheel, neither crossing the line nor being too far away from the edge line; Or, conversely, Dallas should pay attention to adjusting the direction in time and hitting the strength and angle of the steering wheel to avoid understeer caused by too fast speed. In addition, care should be taken not to exceed or press the yellow marking. Third, after the implementation of the new regulations on side parking, there is no longer a benchmark for side parking, and the garage boundaries are all made in the form of ground markings. Scoring standard: those who get out of the line after parking, those who don't stop in the garage, those who stop halfway, are unqualified. Don't open the left turn signal button when starting 10, don't open the right turn signal button when reversing 10, and the wheel touches the lane sideline button when driving 10. 1, 20 points will be deducted when the tire runs into the garage and lane line; 2, after the vehicle storage stopped, the depot qualified, deducted 20 points; 3. After warehousing, 5 points will be deducted for improper body position; 4, one into a retreat, failed to warehousing, 20 points. 1, adjust the seat and rearview mirror after getting on the bus; Place the front door handle in the middle of the rearview mirror, one third from the root of the rearview mirror. 2. Start with semi-linkage, advance slowly and in parallel along the parking space, and stop when the distance between the rear of the car and the line is about 1 m; 3. Hang the reverse gear, press the horn once, hit the right turn signal, and prepare to reverse the car in place; 4. When reversing, look at the right rearview mirror. When the 1 line disappears in the right rearview mirror, turn to the right and drive slowly at the same time, then look at the left rearview mirror; 5. When the intersection of Line 3 and Line 4 appears in the left rearview mirror, turn left twice and drive slowly at the same time; Continue to observe the left rearview mirror; 6. When the left rear wheel is about to press line 2, quickly make a directional compensation to the left; 7. Drive slowly while observing the rearview mirror. When the car body is parallel to Line 2 and Line 4, turn back to the right and stop. 8. Step on the clutch, shift to 1, turn on the left turn signal, press the horn once, and start slowly with semi-linkage; 9. The car drives on the left. When the right front corner of the car crosses the 1 line, return to the right side for 2 laps as soon as possible. After the third lap, it depends on the distance from Line 2 to decide how many laps to play. 10, the front is on time, turn left 1 circle, and keep going. Tips: kill the steering wheel to the right and reverse the car; When looking at the left rearview mirror, the rear door handle should be about 3 cm away from the yellow marking; When the steering wheel turns back, the car backs up. On the way, the steering wheel slammed to the left, then turned on the turn signal normally and drove out of the yellow box mark. Fourth, after the implementation of the new parking regulations, students can't stop halfway. Once they stop, they will fail the exam. Scoring standard: those who do not follow the prescribed route or sequence, do not completely dump into the warehouse, and stop halfway are unqualified. Forward to the starting point: the car travels from point C to point A, and uses the left assembly line to move forward against the right edge of the starting white line. When the left door and window column faces the upper edge of the starting white line, step on the clutch and brake to stop; This is the starting point for reversing. Reverse the garage to the right: 1. Put the reverse gear on, release the clutch when it vibrates slightly, release the brake and reverse the car. When the lower edge of the left rearview mirror covers the lower edge of the starting white line, the steering wheel will be killed to the right (one and a half turns to the right). At this time, I immediately began to look at the left rearview mirror. 2. Look at the left rearview mirror. When you see the corner on the left side of the garage in the left rearview mirror, turn the steering wheel half a turn to the left. Then look in the right rearview mirror. 3. Look at the right rearview mirror. When the car body is parallel to the line of the garage, turn left. At this point, the steering wheel has been turned back, and then look at the left rearview mirror immediately. 4. When the lower edge of the left rearview mirror covers the lower edge of the garage door narration line, step on the clutch and brake to stop. At this point, the car has been put into storage. Forward feed: 1, put in first gear, slightly shake to release the clutch, release the brake and move forward. 2. When the first two corners of the car cross the white line opposite the garage, the steering wheel is killed to the left, and the car body is parallel and then aligned. At this time, the car arrived at area C, and after merging, it continued to drive forward. When the left door and window column is right on the upper edge of the white line, press the clutch and brake to stop. Left anti: 1. Put in reverse gear, release the clutch when there is slight vibration, release the brake and reverse the car. When the lower edge of the left rearview mirror covers the upper edge of the white line, the steering wheel will die to the left (one and a half turns to the left). At this time, I immediately began to look at the right rearview mirror. 2. Look at the right rearview mirror. When you see the corner on the right side of the garage in the right rearview mirror, turn the steering wheel half a turn to the right. Then look in the left rearview mirror. 3. Look at the left rearview mirror. When the car body is parallel to the garage line, turn back to the right. At this point, the steering wheel has been turned back, and then look at the left rearview mirror immediately. 4. When the lower edge of the left rearview mirror covers the lower edge of the garage door narration line, step on the clutch and brake to stop. At this point, the car has been put into storage. 5. Put on the first gear, slightly press the brake clutch and move forward. When the front two corners of the car cross the white line opposite the garage, the steering wheel is killed to the right, the car body is parallel, then it is straightened, and the car drives out of the test area and backs up. Tips: You can pause for a while before preparing for storage. Students can take this opportunity to observe the garage sideline with the rearview mirror and decide the angle of the steering wheel when reversing. The car body should keep a distance of 1.5 m to 1.8 m from the sideline, and the infrared ray at the front of the car begins to reverse slowly; The vertical lining of the triangular window on the right side of the back door should coincide with the upper right corner of the yellow border. If the direction is dead, you can reverse the car and put it in storage. When practicing at ordinary times, you must use the clutch more, learn to use the clutch flexibly to control the speed, so as to be slow and non-stop, keep the speed at about 5 kilometers per hour, and slowly complete the whole inverted pole action. 5. The new regulations on fixed-point parking and starting on ramps stipulate that the steep slope must be greater than or equal to 10 degrees, and the length of the steep slope with C 1 driver's license should be greater than or equal to 20 meters. Scoring standard: After stopping on steep slope, it must be started within 30 seconds. If the vehicle is driving on the solid line on the edge of the road, there is no fixed-point parking, the front bumper of the vehicle does not reach the control line after stopping, and it slips back more than 30 cm after stopping, and the starting time is more than 30 seconds (the test item with the most students falling off horses). Slip back less than 30cm after parking 10 point, start without turning on the left turn signal button 10 point, stop the front bumper without reaching the stop line button 10 point, and stop the right front wheel more than 30cm from the edge line 10 point. Tips: First, you should learn to use the pedal clutch in normal training. During the exam, as soon as you get on the test car, you will know how high the clutch of this car needs to be lifted to be in a semi-clutch state. The second is accurate fixed-point parking. People's binocular vision will have virtual errors. Obviously, they feel stopped at a fixed point, but in fact they have passed the stop line or haven't reached it yet. In view of this situation, when driving to the test center, it can be determined that the front windshield sign overlaps with the marking line. The right front wheel of the car should be 30 cm away from the yellow marking, and the front of the car should stop on the yellow marking. Fixed-point startup time should not exceed 30 seconds. When starting, pay attention to gently release the clutch, at the same time, lightly step on the accelerator, and then release the brake to prevent slipping back.