I would like to ask what are the precautions for a new home inspection. Does anyone know about it? Can you tell me? What aspects need attention?

Hello, now everyone knows that the quality of houses is becoming less and less guaranteed, so they will inspect the house during the flash house, so you need to be careful during the house inspection. Check each corner carefully. So what are the precautions for new home inspection? Below are 15 precautions for new home inspection and 5 pieces of knowledge about the home inspection process. You can refer to them. 1. Whether the floor is flat. If you want to check whether the floor is flat, you only need to use a long ruler (or a special ruler with a level) and lean it against the wall to check whether it is flat. At the same time, observe whether there are scratches and cracks on the wall and whether there are any cracks on the wall. Exploding point (exploding point: When quicklime is mixed with hydrated lime, it is not stirred evenly, so it will form an exploding point when applied to the wall. When you hit the "exploding point" with an iron tool, you will find a large area of ??looseness, falling off, etc. Question. ) 2. Whether there are cracks on the wall. While checking whether the wall is flat, you also need to check whether there are cracks on the wall (four common cracks: strength cracks, settlement cracks, temperature cracks, deformation cracks) and whether there are leaks. barbed wire and steel bars. If the above wall problems are discovered during the home inspection, the developer can help repair them before signing. 3. Whether there are any defects on the indoor stairs. It mainly depends on the flatness of the stairs and whether there are any defects. 4. Whether the installation tracks of doors and windows are smooth. When inspecting doors and windows, the most important thing is to check whether the tracks of doors and windows are smooth. Especially those with casement windows must pay attention to whether they can be closed tightly. Otherwise, wind will enter the room, especially in the cold north, and you will be in trouble in winter. If these problems are discovered during the re-inspection, notify the developer directly and they will fix them quickly. If you have already signed the contract, go to the developer to deal with these problems. Then their work efficiency will be very slow. The second aspect is to check whether the door and window glass of the new house is damaged. Is the window frame deformed? If you find any abnormalities, please contact the developer immediately to resolve them. This is something that requires your attention. In particular, the doors and windows of each room must be carefully inspected to avoid unnecessary loss of money. 5. Whether the entrance door is bumped or painted. You need to carefully check whether the entrance door is bumped or painted. Strictly speaking, the inside, outside, and top of the door must be painted. The gap between the door should not be too large. There should be no special sound when the door opens and closes. The four sides of the door should be close to the door frame. The gap on one side of the door lock should not be too large. At the same time, don't forget to test the lock, mainly to see if the key is easy to use, and Is the door lock installed firmly? Other important points are that the door has good sound insulation and is well sealed. Precautions for new home inspection (detailed steps will teach you how to conduct a home inspection) Bump marks on the entry door 6. Balcony equipment is not damaged When inspecting a balcony, the main thing to check is whether the floor of the balcony is flat and whether there is any damage, and secondly whether the balcony window equipment is intact. 7. The floor height cannot be less than 2.8 meters. The building height regulations for buildings are generally 2.8 meters. The actual height cannot be less than 2.6 meters. The actual height of a floor height of 3 meters cannot be less than 2.75 meters. However, the floor height of residential buildings cannot be less than 2.8 meters. . 8. Whether the water supply is complete. When checking to whom, the main thing to check is whether the faucets of each water pipe in the room have water supply and whether they are complete (including the faucets in the pipe wells in the corridor). 9. Is drainage normal? After having water supply, the remaining big problem is to solve the drainage problem. The locations for checking and accepting drainage are mainly at basins, toilets, bathtubs, and floor drains in bathrooms, kitchens, and balconies (there should be a gurgling sound and there should be no accumulation of water on the surface). There should be no accumulated water on the qualified floor, because the floor drain is the lowest point, but a certain height of the floor for later paving is left around the floor drain of the rough house. Make the water flow as large and urgent as possible, check the water pressure, and test the drainage speed. 10. Is the electrical quantity consistent with the purchased quantity? The first step in the electrical inspection is to check whether the water and electricity in the electricity card and water card are consistent with the purchased quantity; 11. Is the reserved hole reasonable? First, check the living room, south and north Air conditioning units and holes in bedrooms. Especially when checking the air conditioning holes, be sure to see if they are high on the inside and low on the outside. If the outside is high and the inside is low, rainwater will pour in when it rains, which is quite troublesome, especially if the air conditioning holes are opened in the north, water flooding will be very serious. If this problem is found, firmly ask KFS to plug the original hole and drill the hole again. 12. Strong current and weak current. When checking strong and weak current, the main thing is to check whether the switch and meter can control indoor lamps and indoor sockets, and check the firmness of switches and sockets.

Check whether the vertical distance between strong and weak current exceeds one meter, otherwise it will affect the TV viewing effect in the future. (This is very important). Use an electric pen/small light bulb to measure whether each strong and weak current is flowing smoothly. Whether the indoor power is completely cut off after the gate is opened. If there is a disconnected gate indoors, check it separately. You can know whether the switch and meter can fully control the indoor power supply. The socket must be a safety socket (sockets 30 cm above the ground must have a safety device). The power sockets in the bathroom should be moisture-proof sockets and have splash-proof measures. , the lighting lamp holder in the bathroom must be a magnetic safety lamp holder, and there should be no socket above the wash basin. 13. Check the flatness of the room. Three major methods on how to check the flatness of the room: (1) Tie a heavy object with a string on the roof, put it against the wall and lower it to the foot of the wall, and check the degree of inclination from all sides. (2) Visually check that the ground is roughly flat. (3) Check the flatness of the wall. Whether the walls and ceiling floors are particularly tilted, whether they are bent or wavy. 14. Check the verticality of doors and windows (1) Whether the latch and door lock of the door, door and door are too long and too tight. (2) Is the door plug inserted too little? Is the door gap too large (especially the door lock side)? (3) Are the four sides of the door close to the door frame? Is there any special sound when the door is opened and closed? (4) Are there any water stains under the windowsill? If so, the window may be leaking. (5) There is no gap between the window edge and the concrete interface. (6) Is the window opening and closing too tight? Can it be closed properly? (7) Whether the window glass is intact. 15. Public *** package (1) Open the line interface of the phone and TV, and pull it hard to see if it is fake. (2) Whether telephone lines, closed-circuit television lines, and broadband are smooth and in place. (3) CCTV monitoring system, building video intercom system, home security alarm system. (4) Peripheral prevention management system, offline intelligent patrol system, background audio and broadcast system. The above fifteen pieces of home inspection knowledge will be helpful to every owner when taking over the house. For the owner, the home inspection should be a very important matter, because only if the house problems are discovered before signing, the real responsible person can be investigated. , to maximize their own interests. This concludes the above notes on home inspections. Home inspections are a very important matter for property owners, because only if problems are discovered before signing, the real responsible person can be investigated and their own interests can be maximized. Therefore, a home inspection is indispensable. That's probably it. The above steps are for reference. I hope it will be helpful to you. I wish you a happy life.