How to disassemble ceramic bracelet

How to adjust the bracelet of ceramic watch? Nowadays, the popular watches in the market, which also represent the fashion elements in the watch industry, are ceramic watches. When buying watches, especially online shopping, we often worry about the strap. When we buy it, the strap can't be completely matched with the wrist. At this time, we often worry about how many watch chains to remove, and we can't let the customer service staff cut them too short. When unpacking the baby, I found that they were too long and had to be adjusted in the watch shop, which was very troublesome. Here we will talk about how to adjust the watch chain by ourselves.

When removing the bracelet of a ceramic watch, the clasp should be taken out from the bracelet through the watch regulator first. Turn the watch handle slowly and push out the clasp, so that the recoil nail can be pushed in the opposite direction during installation. When adjusting the bracelet, it is common that the bracelet is connected with the watch case by thread. This matching bracelet has six concave shafts, ten squares and ten squares. When opening the ceramic band, you can use a special watch adjuster that matches its shape. Put the ceramic watch band into the "watch unloading slot", and then forcibly eject it according to the needle interface on the watch regulator, and remove the watch chain. The watch chain is closely connected with the back cover, which is often used for old watches and little girls' watches. Maintenance personnel can use appropriate tools to rotate the knob of the watch adjuster to the outermost position to align it with the "strap connecting pin", and then slowly rotate the knob to eject the "pin". Finally, push back the "pin" reversely during installation. If not, you can pry up the back cover in the direction where there is a large gap between the stud and the bracelet, preferably symmetrically, so as not to damage the back cover. Special reminder to remove the removed watch section, re-nail it with a watch chain nail, and use the rubber head side of a small hammer to avoid accidentally hammering the watch.