Installation details of plate-type high-box bed

How to install plate high box bed? Next, I will talk about the installation steps of the plank bed. Please open the corresponding package according to the installation steps before installation, so as to avoid confusion of plates and unnecessary installation difficulties. When installing the product, remember to protect the sponge under the product to prevent the product from being scratched.

Installation plate type high box bed

Installation of accessories: check whether the accessories are complete.

Installation steps:

Step 1: Install the bed.

First, put three screws and a raft on the left and right panels.

On three sides of the spiral, two plates are fixed on the long water plate respectively.

And locked with a three-in-one lock handle.

As shown in the figure, the short line supports and fixes the middle blade and the long rod.

Lock both ends of the footboard of the bed, as shown above, so that 13 is on a screw and raft.

Lock the pedal and the left and right side plates with screws.

Foot code between safety pedal and 6 mm flat head screw side plate.

As shown in the above figure, install the bed rod with the left and right side plates of the self-tapping nail bed. Put the bottom of the bed last.

Step 2, install the wooden bed.

Connect the gas pressure bar with M6* 20 flat head screw.

Tighten with M6* 20 grub screw.

The left and right side plates of the pneumatic rod are fixed with M6×20 flat head screws.

Fix two air pressure rods on the big bed board.

The outsole is fixed on the pneumatic rod with M8×45 flat head screws, and fixed with nuts and a layer.

Installation completed