How to install tiles on the upper wall of big tiles and how to stick them on the upper wall without falling off.

When we buy a house of our own, the most concerned issue is the decoration of the house. Many materials, such as tiles, will be used in the decoration. Now the installation of tiles is also very important, which will directly affect the appearance, so you must be careful when choosing tiles. Let's talk about how to install large tiles on the wall. When we buy a house of our own, the most concerned issue is the decoration of the house. Many materials, such as tiles, will be used in the decoration. Now the installation of tiles is also very important, which will directly affect the appearance, so you must be careful when choosing tiles. Let's talk about how to install large tiles on the wall. Why can't the floor tiles stick to the wall?

How to install large tiles on the wall

At present, there are two common paving methods, dry paving and wet paving.

Dry paving: firstly, grind grooves on the back of the brick body, bury copper wires and fix them with structural adhesive, and then fix them with the wooden keel attached to the wall with structural adhesive. This paving method is usually used to lay the TV background wall. Generally, a wooden keel is made at the position of the TV background wall first, and then a 12-cm board or a 9-cm multilayer board is sealed; Then, the upper part of the back of the floor tile is slotted and copper wires are hung; Locate the floor tile, and fix the screws and copper wires above the corresponding positions (here, the copper wire is equivalent to the seat belt of the tile); Finally, the back of the floor tile is coated with structural adhesive and laid directly.

Wet paving: The general steps are the same as dry paving, except that the wet paving method is to spread the floor tile on the cement wall with cement mortar with fine sand, and the wall must be roughened to increase friction before laying.

In addition, there will be a lot of powder on the back of the new tile, so it must be cleaned before paving. Even if the water absorption rate of floor tiles is small, they should be fully soaked, and at least soaked for more than 2 times before paving. Because the process is relatively complicated, the labor cost of laying walls with tiles of the same area is usually more than twice that of laying floors directly.

Why don't tiles stick to the wall and fall off?

1, determine the height and size, and choose the paving method; The first thing to pay attention to when paving wall tiles is to determine the height of paving, especially the bathroom, which will prevent exhaust fans and install suspended ceilings, so pay special attention to the height; Secondly, the size of wall tiles and floor tiles should correspond, and there should not be much difference; Finally, the paving method is determined according to the height, size and overall effect. If the unified wall tiles are different, the large-size tiles are pasted from bottom to top, and the small-size tiles are pasted from top to bottom.

2. Uniform paving and edging: When paving wall tiles, it is necessary to pay attention to the horizontal and right angles between each tile to keep it flat; Secondly, it is necessary to confirm the first-class flatness of the high and low points of the tile and the edge wrapping after paving.

3. Close the edges and caulk after paving: after paving, confirm the paving effect of the whole wall, whether there is any scheme error in color and pattern, and clean the surface of ceramic tile; Make sure that the tile is correct before caulking it.

The above contents are all about how to install large tiles on the wall and how to stick the tiles on the wall. Nowadays, many people like to install it on the wall when decorating, but it will be easy to empty when installing tiles, and rework will be more troublesome. Moreover, there are new ways to install tiles, which can be more solid.