Joke Collection Website - Cold jokes - How to maintain the old and new mahogany furniture

How to maintain the old and new mahogany furniture

The first step is to repair the paint:

If wax oil drips on the furniture paint, don't scrape it with a sharp knife or nail. When the light is good during the day, use plastic sheets, hold hands tightly, lean forward, slowly scrape wax oil from the front of your body, and then wipe it with a fine cloth; If there are scratches on the paint surface of furniture, you can cover the exposed background color on the wound surface of furniture with crayons or pigments consistent with the color of furniture, and then apply a thin layer of transparent nail polish. If the paint surface of furniture is burnt, you can wrap a layer of fine-grained hard cloth on the toothpick, gently wipe the traces, and then apply a thin layer of wax to remove the scorch marks.

The second trick is to repair the dent:

Some furniture will leave dents after collision because the wood is soft. At this time, you can put a wet towel on the concave part first, and then press it with an iron to restore the original state. If the dent is deep, filler should be added.

The third measure is to repair cracks:

If cracks appear in solid wood furniture due to thermal expansion and contraction, the following remedial measures can be taken; Burn old cotton cloth or broken sacks into ashes, then stir them into paste with raw tung oil, embed them in the gaps of wood products, and dry them in the shade to make them flat and firm.

The fourth move furniture surface bulge:

After the decorative veneer bubbles, you can first cut a knife in the middle of the bubble along the grain direction with a sharp blade, then inject glue into the joint with a syringe, gently press it on the upper part of the bubble with your fingers, wipe off the spilled glue with a wet cloth, and then press it with a heavy object with a smooth bottom surface larger than the bubble area. In order to prevent a small amount of glue from overflowing and damaging the peripheral surface of bubbles after pressurization, plastic films can be covered on the bubbles to separate them, so that the decorative veneer will be flat.

The fifth measure is to eliminate water marks:

Water drops on furniture will leave traces of water stains if they are not dried immediately. At this time, cover the trace with a wet cloth, and then carefully press the wet cloth several times with an electric iron. The water in the trace will evaporate when heated, and the water trace can be eliminated.

The sixth measure is to repair cracks:

If cracks appear in solid wood furniture due to thermal expansion and cold contraction, the old cotton cloth or broken sacks are burned to ashes, and then mixed with raw tung oil to form a paste, embedded in the cracks in the wood, and can be repaired and bonded after drying in the shade. Or, tear the newspaper to pieces. Add some alum and water, boil it into a thick paste, cool it and apply it to the cracks in the wood. It is also very strong after drying.

Seventh move furniture rust removal:

Chrome-plated furniture is rusty, so don't use sandpaper to polish it. Small electroplated parts can be soaked in a basin filled with engine oil for 8 to 10 hours, and then wiped with a cloth. However, if the furniture with large electroplated parts is rusted, you can apply a brush or cotton gauze to the rusted place first, and then wipe it with a cloth for a while to remove the rust. With these tricks, you will definitely change the "face" problem of your furniture.