The unit displayed on the weighing scale is ST, how to convert it?

ST on the scale is the unit of weight. ST = stone stone 1 stone =6.35 kg. Si Tong (English: Stone, abbreviated as st) is one of the British units of mass used in the British Isles, and is also widely adopted by Commonwealth countries. Before adopting the metric system, many Nordic countries also used Shi Ying as the unit of mass.

For example: st: Gong's1ST = 6.35 kg; 1lb = 0.45kg； So 7: 2 1/2 should be: 7 * 6.35 = 44.45kg 21/2 * 0.45 =1.125kg, so the total is 45.575kg

Extended data:

Instructions for use of weighing scale:

1. measurement: after the boot is completely displayed to zero, it can be weighed, and after the weight is stable, it blinks for three times, which is the effective weight value. When you get off the scale and then put it on the scale, you can weigh it again. When the locking value increases by more than 5KG after locking, it will be unlocked and weighed again. /kloc-Shut down after 0/0 seconds, without any operation.

2. Calibration.

1) For uncalibrated scales: when the power-on display corresponds to 0.0, the scale platform will be weighed; when the value displayed on the lED screen exceeds 80.0kg, the internal code will be automatically input, and the calibration has been triggered. After lifting weights, the LED will display "CAL" for one second, and the LED scale will display 50.0KG, prompting to release the standard 50.0KG.

Put the weight, and the lED will display the internal code change corresponding to 50.0KG. When it is stable, it will display the prompt of 100.0KG, and put the standard 100.0KG (plus 50kG). When the weight is put on, the LED will display the internal code change corresponding to 100.0KG, and when it is stable, it will display the prompt of 150.0KG, and put on the standard100.0kg..

When the weight is put on, the lED will display the internal code change corresponding to 150.0KG, and when it is stable, it will display PASS, and the calibration will return to the weighing mode.

2) For the calibrated scale: when the power-on display corresponds to 0.0, increase the weight by 50.0KG(+/-5.0KG) and lock it. Add 100.0KG(+/-5.0KG) and the internal code will be entered when it is stable. At this time, the calibration has been triggered, and the following process is the same as above.