How can I make the household electric meter go slower?

Anti-stealing measures for single-phase electric meters In order to improve safety production and economic benefits and protect their own interests, station area managers should regularly check and clean up the electric meters and lines of all users in the whole area. After instrument calibration, the following points should be noted during installation: 1. When installing the electric meter, try to unify the color of wires, and connect wires with different colors on different phase lines. And absolutely ensure that the 1 terminal of the electric meter is the live wire and the 3 terminal is the zero line. After the incoming line is installed, in order to prevent some users from disconnecting the main zero line for private grounding, use an electric probe to measure whether there is induced electricity at the 3 rd and 4 th ends of the incoming line. If it doesn't show that the line is normal, if it does, it may be that the main line to the electricity meter has been disconnected. It is necessary to find out the location of the breaking point immediately and analyze whether it is artificially broken according to the breaking point. If it is disconnected artificially, the user will be listed as the key inventory object. If everything is all right, connect the terminals of the meter. After the wires are connected, turn all the screws of the terminal and the connecting screws of the electric meter again. And make sure it is firmly connected. Second, cover the electric meter terminal cover plate and seal it with lead. When sealing with lead, tie a knot after wearing the lead sealing line to shorten the lead sealing line as much as possible. Move the lead sealing block to the knot and seal it with lead. Select a tissue seal, write the user name and paste it. Third, check whether the user's leakage protector can normally disconnect the power supply. If damaged, it must be replaced immediately. If it is normal, use an electric probe to measure whether there is a fire at both ends of the outlet. Disconnect the power supply, connect the line to the user's home and close the switch to see if the power consumption is normal. If the leakage protector can't be turned off, it means that there is something wrong with the line in the user's home, so check the user's line. Don't be afraid of trouble and don't install it, otherwise there may be two results, and both of them will lead to the failure of general protection in Taiwan Province: (1) Users set up ground wires at home privately to steal electricity. (2) The line failure in the user's home may lead to safety accidents. Four, for the area where no leakage protector is installed, you should bring your own leakage protector to check the user line. Check the meter box again to see if it is intact or defective. If it's not sealed with lead. When sealing with lead, tie a knot after wearing the lead sealing line to shorten the lead sealing line as much as possible. Move the lead sealing block to the knot and seal it with lead. Choose a thin paper envelope, write down the user's name, site number and power consumption propaganda slogan, and then paste it. And publicize some basic common sense of electricity use to users. Six, after the meter is cleaned up, it is the monthly inspection work. As a district manager, you don't just charge electricity to complete the task. It is most important to manage the station area, improve line loss and ensure safety. Take time to visit the Taiwan Province area, especially at night when the phenomenon of drought resistance is serious. Try to make more noise in the jurisdiction, let users know that you are not only in the jurisdiction during the meter reading and charging period, so that thieves dare not steal electricity blatantly. Seven, monthly meter reading, focus on checking whether the lead seal and paper seal of the following meter are damaged. Is there anything on the main line that shouldn't appear? It would be best if we could form a support group with several administrators in Taiwan Province to check the lines and deal with electricity thieves. This is safe, and it can also give the thief a shock. Try to catch a thief in each district and hand it over to the judicial department as an example. Several people joined forces to cut green and sweep obstacles in various districts and clean porcelain bottles on telephone poles. Do it backwards!