What are the general safety requirements for machining workshops?

1. The distance between mechanical equipment and small equipment shall not be less than

.7 m; Medium-sized equipment is not less than 1 m; Large equipment is not less than 2 m

. Operators and equipment shall be placed back-to-back or staggered back-to-back. The main channel should be marked with white lines or warning signs.

2. Workpieces, blanks and tools should be kept in order. What are the general safety requirements for machining workshops? The height should not exceed the rotating part of the machine.

3. inflammable and explosive articles such as gasoline and kerosene can't be stored for a long time on the job site, so they should be sent away in time after use.

4. Clean up the iron filings and cotton yarn in time

5. Wear labor protection articles as required when entering the operation post. You are not allowed to be naked in summer, wearing vests, shorts, skirts, high heels, sandals, etc.

6. Daylighting, the production site should have sufficient illumination. Daylighting can be divided into natural lighting and artificial lighting. When natural lighting can't reach the illumination during the day, artificial local lighting should be adopted. The general operating illumination is about 15 LUX, and the precision operation should be about 3 LUX. When the span of the workshop is more than 12 m, two sides of the single-span workshop should have side windows for lighting, and the width of the window should not be less than half of the width of the bay. Multi-span factories are connected, and each connected span should have a skylight, and there should be no wall between spans. The lighting of workshop passage shall cover all passages, and the coverage length shall be greater than 9% of the length of workshop safety passage.

7. Requirements for ground conditions. The width of sidewalks and carriageways shall comply with safety regulations; Pits, trenches and pools should have reliable protective fences or cover plates, and should be illuminated at night; Industrial garbage, waste oil, waste water and waste in the production site should be cleaned up in time; The floor of the production site should be flat and free of stumbling blocks.